Thermaltake Pacific MX1 Plus User manual

E
BB
A
D
H
C
This product is intended for installation only by expert users. Please consult with a qualified technician for installation.
Improper installation may result in damage to your equipment.
Before you start using this product please follow these basic guidelines:
1. Please carefully read through the instruction manual before beginning the installation process.
2. Please remove your graphics card from your motherboard to insure the safest process and in order to prevent
any possible damages to your CPU and motherboard.
3. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant Series.
Intel LGA1366,LGA1200,LGA115x Intel LGA2066,2011-3,2011
AMD
A
J
J
D
F
C
JGG
E
A x 1
B x 2 C x 1 D x 4
F x 4 G x 4 H x 4 J x 1
I x 1
E x 4
Parts
List
Water Block
AMD clip
Thermal grease
Screw Screw
Washer
Backplate Screw Screw
Wrench
1.FM2/FM1/AM3/AM2
2.AM4
3.LGA1366
4.LGA1200/1156/1155/1151/1150
F
G
A
Pacific MX1 Plus
E
A
A
I
I

Controller Parts List
Controller Power Cable Velcro Controller Cable
Kx 1 Lx 1 Mx Px 1
Installation Guide
1
3
2
Install the Water Block on the mainboard properly,
and connect the water block cable to the conversion cable.
Connect the plug into the port in numerical order,
start with plug one.
1
Set the DIP switch on the back side of the controller to assign
the number of the controller
NO.1
ON
1 2 3 4
NO.3
ON
1 2 3 4
NO.2
ON
1 2 3 4
NO.4
ON
1 2 3 4
NO.9
ON
1 2 3 4
NO.11
ON
1 2 3 4
NO.10
ON
1 2 3 4
NO.12
ON
1 2 3 4
NO.5
ON
1 2 3 4
NO.7
ON
1 2 3 4
NO.6
ON
1 2 3 4
NO.8
ON
1 2 3 4
NO.13
ON
1 2 3 4
NO.15
ON
1 2 3 4
NO.14
ON
1 2 3 4
NO.16
ON
1 2 3 4
L
L
4
Connect the controller cable onto the mainboard
(USB 2.0 9 pin) and controller.
5
Connect the power cable to the 4pin Molex connecter
and controller.
M
M
Conversion Cable
Nx 1
K
123
4
5
N
© 2020 Thermaltake Technology Co., Ltd. All Rights Reserved. www.thermaltake.com
Bridge Cable
Ox 1
OO O
6
ON
1 2 3 4
TEMP. Controller Plus Controller Quad / Trio Controller
1. Pacific MX1 Plus is only compatible with Temp controller
2. Connect the controller cable to Temp controller ,
and then connect the rest of controllers in series
Connect with other addressable LED product
Pacific MX1 Plus is only compatible with Temp controller