Thermaltake TOUGHLIQUID 360 ARGB TRX40 Edition User manual

Intel Installation Guide
Parts List
A x 1
G x 12
H x 12
B x 3 C x 1 D x 4 E x 4 F x 1
K x 1J x 1
I x 1
Installation Guide
12
3
5
4
6
A
CD
E
G
B
H
F
Scan Here
Installation Guide
TOUGHLIQUID 360 ARGB
TRX40 Edition
FAN
CPU_FAN
PWM
B
I

© 2022 Thermaltake Technology Co., Ltd. All Rights Reserved.
www.thermaltake.com
ARGB Controller Installation Guide
1. Light Mode:
Switch over between 7 LED modes.
3. Light Speed:
Switch over between 4 light modes.
When light mode is in RGB Spectr um:
Click to memorize and lock the color you want, click again to unlock the 256
colors auto rotation.
Red → Yellow → Green → Teal → Blue → White → Purple
When light mode is in Ripple :
Switch over 7 LED colors .
When light mode is in Wave and Flow :
LED color can not be adjusted.
Red → Yellow → Green → Teal → Blue → White → Purple → Rainbow
2. Color Mode:
When light mode is in Full Lighted, Pulse and Blink :
Switch over 8 LED colors .
Rainbow → Full light → RGB Spectrum → Off → Flow → Radar → Pulse → Blink
Slow → Normal → Fast → Extreme
MB SYNC Installation Guide
1. To use Motherboard RGB Software, please only
connect Cable K to the water block
2. Please power off the PC and check the Positive
and Negative ends on the connector before
connecting the cable to the mainboard.
Connecting the wrong end can damage the product.
CAUTIONCAUTION
CAUTIONCAUTION
Installation Guide
1
1
To use the ARGB Controller, please only
connect Cable J to the water block
2
2 3
SATA A
PUMP
PUMP
Open the cap
counterclockwise, and
lock it in clockwise
direction. Set the logo
to an angle that fits your
setup better.
Open Close
7
8
J
J
K
A
J K
K
A
MODE
COLOR
SPEED