Thermaltake Toughpower 800W User manual

TM
Toughpower 700W / 800W TM Toughpower 700W / 800W
Copyright 2008 Thermaltake Technology Co., Ltd. All Rights Reserved.
All trademarks are the property of their respective owners.
Reproduction in whole or in part without written permission is prohibited.
C
Toughpower 700W / 800W
TM
ATX 1 2 V 2 . 2 & EP S 1 2V 2 .9 1 Ver s i o n
www.thermaltake.com

TM
Toughpower 700W / 800W TM Toughpower 700W / 800W
Table of contents
01. Warnings & Caution -----------------
02. Components Check -----------------
03. Power Connector Introduction --
04. Installation Steps --------------------
05. Product Features -------------------
06. Output Specification ----------------
07. Total Protection ----------------------
08. EMI & SAFETY -----------------------
09. Environments -------------------------
10. Trouble Shooting ---------------------
01
02
03
04
05
06
06
07
07
07

TM
Toughpower 700W / 800W TM Toughpower 700W / 800W
1. Do not unplug the AC power cord when the power supply is in
use. Doing so may cause damage to your components.
2. Do not place the power supply in a high humidity and/or
temperature environment.
3. High voltages exist in the power supply. Do not open the
power supply case unless you are an authorized service
technician or electrician. Doing so will void the warranty.
4. PSU should be powered by the source indicated on the rating
label.
5. All warrantees and guarantees will be voided, if failure to
comply with any of the warnings and cautions covered in this
manual.
1. Warnings and Caution 2. Components Check
01 02
Toughpower 80Plus (Silver)
/ power supply unit 700W 800W
User manual
AC power cord
Mounting screw x 4
Silicone rubber mounting
gasket x 1
Cable strap x 4

TM
Toughpower 700W / 800W TM Toughpower 700W / 800W
3. Power Connector Introduction
MODELS
Connector Type Connectors & Cable length
700W
800W
20+4pin
ATX 12V 4pin
EPS 12V 8pin
Molex & FDD
SATA
PCI-E 8/6pin
4. Installation Steps
1 x 20+4pin Main connector
(500mm)
1 x ATX 12V 4pin connector
(500mm)
1 x EPS 12V 8pin connector
(500mm)
2 x Peripheral & 1 x FDD connectors
(500mm + 150mm + 150mm)
3 x connectors
(500mm + 150mm + 150mm)
Peripheral
3 x S-ATA connectors
(500mm + 150mm + 150mm)
3 x S-ATA connectors
(500mm + 150mm + 150mm)
1 x 8/6pin PCI-E connectors
(500mm + 150mm)
1 x 8/6pin PCI-E connectors
(500mm + 150mm)
03 04
Cable
P/N Model
W0295 700W
W0296 800W
1 1 1 6 51 2 2 2
1 1 1 6 51 2 2 2 1. Open your computer case; please refer to the direction in your
case manual.
2. Install the PSU into the case with the four screws provided.
3. Connect the 24 pin Main Power Connector to your motherboard
and peripheral. If your motherboard uses a 20-pin
connector, detach the 4-pin attachment on the 24-pin connector.
4. Connect the 8-pin or 4-pin connector for the CPUs.
5. Connect other peripheral power connectors to devices such as
hard drives, optical drives, etc.
6. Close your computer case and connect the AC power cord to
the power supply AC inlet.
Note: The detachable 4-pin section cannot be used in place of a 4-pin +12V
connector.
Note: Make sure that your system is turned off and unplugged.
Disconnect the AC power cord from your old power supply.
20+4pin Main
Connector
4pin +12V CPU
Connector
8pin +12V CPU
Connector
SATA
Connector
Peripheral
Connector
Floppy
Connector
PCI-E (8 to 6)
Connector
6pin PCI-E
Connector
8pin PCI-E
Connector

TM
Toughpower 700W / 800W TM Toughpower 700W / 800W
5. Product Features
05 06
- Stable 700W / 800W continuous output.
- 80 Plus (Silver) certified.
- High efficiency (88% @ 115V & 230V input).
- Intel ATX 12V 2.2 and EPS 12V 2.91 Compatible.
- Universal AC input 100~240V automatically scans and detects
the correct voltage for different country.
- Supports Dual Core CPU / Quad Core CPU / NVIDIA SLI & Quad
SLI and all Multi-Core GPU technologies.
- Active PFC (PF>0.99).
- High reliability: MTBF>120,000 hours.
- Protections: Over Current, Over Voltage, and Short-Circuit
protection.
- Safety / EMI Approvals: UL, CUL, TUV, CE, FCC, BSMI,
GOST certified
TOTAL
POWER
+5Vsb
-12V+12V1
+3.3V +5V
Voltage
MODEL
INPUT VOLTAGE: 100V-240V~, FREQUENCY: 50HZ-60HZ
700W
3.5A
17.5W
0.5A
6W
30A
672W
24A 30A
170W
MAX Load
Combined
Wattage
700W
800W
3A
15W
0.5A
6W
30A
792W
24A 30A
150W
MAX Load
Combined
Wattage
800W
6. Output Specification
7. Total Protection
Over Voltage Protection
W0295 (700W) / W0296 (800W)
Voltage Source
+3.3V
+5V
+12V
Protection Point
3.76V-4.8V
5.6V-7V
13.5V-16.5V
Short Circuit Protection
Activated when any DC rails short circuited.
+12V2
35A
40A
Over Current Protection
W0295 (700W)
Output Voltage
+3.3V
+5V
+12V1 DC
+12V2 DC
Max. over current limit
35.0A
40.0A
40.0A
45.0A
W0296 (800W)
Output Voltage
+3.3V
+5V
+12V1 DC
+12V2 DC
Max. over current limit
35.0A
40.0A
40.0A
55.0A

TM
Toughpower 700W / 800W TM Toughpower 700W / 800W
8. EMI & SAFETY
9. Environments
07
SAFETY Standards
EMI Regulatory
UL, CUL, CE, FCC, BSMI and GOST certified.
W0295 (700W)
W0296 (800W)
FCC Part 15 Subpart J, Class B 115 Vac operation
CISPR 22 Class B 230 Vac operation
Humidity
Temperature Range
Operating
Storage
Operating
Storage
o
+10 to +40 C
oC
o
-10 to +60 C
oC
5-95% RH, Non-condensing
5-95% RH, Non-condensing
W0295 (700W)
W0296 (800W)
If the power supply fails to function properly, please follow the troubleshooting
guide before application for service:
If the power supply is still unable to function properly after following the above
instruction, please contact you local store or Tt branch office for after sales service.
You may also refer to Thermaltake's website for more technical support:
1. Is the power cord plugged properly into electrical outlet and into the
power supply AC inlet?
2. Please make sure all power connectors are properly connected to all
the devices.
3. If connected to a UPS unit, is the UPS on and plugged in?
www.thermaltake.com
10. Trouble-Shooting