Thetford C500 User manual

Demounting instruction C500
Page 1 of 3
Starting from the season 2011 Hobby will replace in the side and front wash room
the conventional Thetford C 400 with the new Thetford version C 500. The model for
the front wash room will be available only in the right version. For the side wash room
however both versions are available (right and left).
Version für Bugwaschraum:
Version front bathroom
Partno. Thetford: 90518
Partno. Hobb :
Version side bathroom room left
Partno. Thetford: 90515
Partno. Hobb :
Version side bathroom right
Partno. Thetford: 90519
Partno. Hobb :

Demounting instruction C500
Page 2 of 3
Removing the C-500:
Thetford C500 completely in-
stalled (side wash room left).
To be able to remove the toilet
without problems, please follow
the steps prescribed below.
First step is to unscrew the lower
connections at the cloakroom wall
because you have to pull out the
wall later on .
Next step is to unscrew the 4 screws of
the tunnel but please don’t remove the
tunnel! This is necessary to be able to
take the cassette out of the washroom
later in process.
Then take out the cover at the bottom
and unscrew the screws below. The
12V cable must be disconnected from
the toilet next.

Demounting instruction C500
Page 3 of 3
The bottom part of the cupboard in
the wash room is divided into
segments, that makes the disas-
sembly of the toilet easier. Un-
screw the left cabinet element and
take it out completely.
After the element of the cupboard has
been taken out, the bottom of the
cloakroom wall should be pulled out
carefully. This is necessary to prevent
that the toilet will damage the stop
bar of the cloakroom wall. The toilet
can now be raised and removed from
the washroom.
Please pay attention that before you
start with the new installation again
the heating and water tubes are
placed correctly.