Tiger Tool 10850 User manual

Automotive Yoke Puller
10850
•
Stay Alert! Watch what you are doing and use common sense when
operating this tool.
•
Inspect product for damage prior to using; do not use if product is
in unsafe condition.
• Do not operate tool while under the influence of drugs, alcohol
or medication.
•
Always use safety equipment to prevent injuries. Approved face
and eye protection must always be worn by the operator, as well
as others in the work area.
•
Do not overreach. Keep proper footing and balance at all times.
•
Dress properly. Do not wear loose clothing or jewelry.
Keep your hair, clothing and gloves away from moving parts.
• Keep your work area clean and well lit.
Operating Instructions
Safety Warning
Read all instructions and safety warnings prior to operation. Failure to do so could
result in equipment damage, personal injury or even death.
1 Remove the large nut and washer retaining
yoke to shaft.
2 Thread the forcing screw into the pull bar until
the threads begin to show through on other side.
3 Holding pull bar assembly by the forcing screw,
position the tool onto the yoke. Pull bar end reliefs
should face yoke.
4
Attach adapter caps by four bolts.
5 Tighten down both caps.
6 Using up to a 1⁄2" impact wrench, begin applying
power to the forcing screw.
7 Continue turning the forcing screw until the yoke
is completely removed.
Here at Tiger Tool, your satisfaction is our number one
priority. Should you have any questions about this or any
of our products, please call us at 1.800.661.4661.
1.800.661.4661
View demonstration videos and a
complete product list at tigertool.com
Technical Support
Have What It Takes

Item No.
1
2
3
Part Number
10850-1
10850-2
10850-3
Qty.
1
2
1
Description
Forcing Screw
Cap
Pull Bar
Parts Breakdown
1.800.661.4661
View demonstration videos and a
complete product list at tigertool.com
Technical Support
Automotive Yoke Puller
10850 Have What It Takes
1
2
3