1
Installation manual
TIFC - Centrifugal fan
G
Fig. 1
Read this manual carefully before using the product and keep
it in a safe place for reference. This product was constructed
up to standard and in compliance with regulations relating to
electrical equipment and must be installed by technically
qualified personnel.
The manufacturer assumes no responsibility for damage to
persons or property resulting from failure to observe the
regulations contained in this booklet.
•Thedeviceshouldnotbeusedforapplicationsotherthanthosespeciedinthismanual.
•Afterremovingtheproductfromitspackaging,verifyitscondition.Incaseofdoubt,
contactaqualiedtechnician.Donotleavepackagingwithinthereachofsmallchildren
or people with disabilities.
•Donottouchtheappliancewithwetordamphands/feet.
•Thisappliancecanbeusedbychildrenagedfrom8yearsandaboveandpersonswith
reducedphysical,sensoryormentalcapabilitiesorlackofexperienceandknowledge
if they have been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be made by children without
supervision.
•Do not use the product in the presence of ammable vapours, such as alcohol,
insecticides,gasoline,etc.
•Ifanyabnormalitiesinoperationaredetected,disconnectthedevicefromthemainssupply
andcontactaqualiedtechnicianimmediately.Useoriginalsparepartsonlyforrepairs.
•Theelectricalsystemtowhichthedeviceisconnectedmustcomplywithregulations.
•Beforeconnectingtheproducttothepowersupplyorthepoweroutlet,ensurethat:
- the data plate (voltage and frequency) correspond to those of the electrical mains
-theelectricalpowersupply/socketisadequateformaximumdevicepower.Ifnot,
contactaqualiedtechnician.
•The device should not be used as an activator for water heaters, stoves, etc., nor
shoulditdischargeintohotair/fumeventductsderivingfromanytypeofcombustion
unit.Itmustexpelairoutsideviaitsownspecialduct.
•Operatingtemperature:0°Cupto+50°C.
•Thedeviceisdesignedtoextractcleanaironly,i.e.withoutgrease,soot,chemicalor
corrosiveagents,orammableorexplosivemixtures.
•Donotleavethedeviceexposedtoatmosphericagents(rain,sun,snow,etc.).
•Donotimmersethedeviceoritspartsinwaterorotherliquids.
•Turnoffthemainswitchwheneveramalfunctionisdetectedorwhencleaning.
•For installation an omnipolar switch should be incorporated in the xed wiring, in
accordancewiththewiringregulations,toprovideafulldisconnectionunderovervoltage
categoryIIIconditions(contactopeningdistanceequaltoorgreaterthan3mm).
•Ifthesupplycordisdamaged,itmustbereplacedbythemanufacturer,itsservice
agentorsimilarlyqualiedpersonsinordertoavoidahazard.
PRECAUTIONS FOR INSTALLATION, USE AND MAINTENANCE