Tork 572028A User manual

Washroom Dispenser Service and Parts Manual
Tork Foam Soap Auto Dispenser
572020A (White) - 572028A (Black) Revision Date: 6-8-10
1
Tork Auto Foam Soap Dispenser
S22 System: 572020A (White)
S22 System: 572028A (Black
Auto Foam Soap Refill Options:
400221: Tork Premium Foam Soap with Lotion Moisturizers 1100ml, 4/cs
400222: Tork Premium Foam Soap Antibacterial with 0.5% Triclosan
1100ml, 4/cs, 400223: Tork Premium Foam Hand Sanitizer Alcohol-Free
with 0.1% Benzalkonium Chloride, 1100ml, 4/cs, 400224A: Tork Premium
Foam Alcohol Hand Sanitizer, 1100ml, 4/cs
Material: PP (Polypropylene): Front Cover, front transparent cover overlay, back plate, refill
pouch holder PP + Talc (Polypropylene plus talc): Electronic housing
Measurements:
Height (H) 11.0 inches (27.9 cm)
Width (W) 5.2 inches (13.2 cm)
Depth (D) 5.4 inches (13.7 cm)
Product Specifications:
Item #
PartNumber Description
Optional Dispenser Labels:
Available from R.R. Donnelley:
Case
Pack SCC UPC Case Size Case Wt Cube
Cases Cases
Per Per
Layer Pallet
572020A 6 10073286622010 073286622013 12.2" x 11.8" x 17.6" 11.76 lbs 1.47 8 56
572028A 6 10073286622027 073286622020 12.2" x 11.8" x 17.6" 11.76 lbs 1.47 8 56

Washroom Dispenser Service and Parts Manual
Tork Foam Soap Auto Dispenser
572020A (White) - 572028A (Black) Revision Date: 6-8-10
Mounting Options:
Mounting Template and Loading Instructions:
A refill loading diagram is located on the back panel of the inner carton.
Surface Mounted Tape
2

Washroom Dispenser Service and Parts Manual
Tork Foam Soap Auto Dispenser
572020A (White) - 572028A (Black) Revision Date: 6-8-10
Direct-to-Wall
3

Washroom Dispenser Service and Parts Manual
Tork Foam Soap Auto Dispenser
572020A (White) - 572028A (Black) Revision Date: 6-8-10
4. Replace the soap refill pouch holder.
5. The dispenser will turn “on” automatically once batteries are installed.*
You will hear a long beep signifying the unit is activated.
* If the dispenser appears non-functional, remove batteries, wait 4 minutes and re-
insert.
Battery Installation
1. Use the dispenser cabinet key to open the front
cover. Insert the key into the holes located at the top
of the dispenser, twisting the key, and pulling the
cover towards you. The cover is hinged at the bottom
of the dispenser.
2. Remove the soap refill pouch holder by pulling it straight up.
3. Insert four C-cell alkaline batteries (not included) making
sure to place batteries in the compartment in the proper
orientation as shown by the diagram in the battery
compartment.
4

Washroom Dispenser Service and Parts Manual
Tork Foam Soap Auto Dispenser
572020A (White) - 572028A (Black) Revision Date: 6-8-10
LED/Tone Indicators:
Tone switch:
When switch is set to ON position there will be one beep.
When switch is set to OFF position there will be two beeps.
LED Indicators and Tone (IR sensor error indications):
Refill
After 2,600 doses a red LED flashes twice every 2 seconds along with two beeps every 8 seconds
indicating the refill needs to be replaced. Be careful to not remove or dislodge the refill while modifying any
settings, as the dosing program will reset.
Batteries
When the batteries are low a yellow LED flashes once every 2 seconds, along with one beep every 16
seconds. 4 C-cell batteries will last 120,000 hand washes or 3 years, whichever comes first.
Object in Sensor Range (within 4 inches of sensing window)
Refill in dispenser -If an object is in the sensor range more then 10 seconds then the green LED will flash
once every second, one beep every 1/2 second. Remove object and unit will operate normally. No refill in
dispenser – If an object is in the sensor range then the green LED blinks once every second and beeps
every ½ second continuously as long as object remains in sensing range.
Dispenser Activation:
1. To activate dispenser, place hand under bottom of dispenser. If a second dose is needed, remove
hand, and then replace hand under dispenser (When an object comes within 4 inches of the sensing
window the dispenser will activate).
2. The dispenser cover must be closed to activate.
Loading Instructions:
1. Open dispenser cover with a dispenser cabinet key.
2. Remove the refill pouch from the packaging box. Place the refill pouch with the nozzle pointing down
into the pouch holder.
3. Remove and discard the nozzle cap.
4. Snap the pouch fitment into the U-shaped bracket insuring the nozzle fits into actuator lever. The pouch
fitment will snap into place once both brackets have snapped over the fitment. At the same time, make
sure the nozzle fits into the slotted actuator lever.
5. The dispenser and dose program resets automatically each time a refill is installed. You will hear a long
beep once the refill is properly installed.
6. Close dispenser cover.
5

Washroom Dispenser Service and Parts Manual
Tork Foam Soap Auto Dispenser
572020A (White) - 572028A (Black) Revision Date: 6-8-10
Removing Empty Refill:
1. Press grey tabs on pouch fitment sideways to release valve.
2. Valve should pop up out of collar.
3. Remove empty bag from dispenser.
Contacting SCA
Before contacting SCA, please locate and make note of the date code circle molded into the back of the
dispenser.
Product Code Date Location: Open dispenser, look on back wall of dispenser a circle (like shown above)
molded into unit. The circle shows an arrow pointing to the month, with the year in the center of circle.
To contact the SCA Tissue Quality Coordinator, dial 1-866-SCA-TORK (866-722-8675) and select # 6.
6