Toro 30856 Manual

All Rights Reserved
Printed in the USA
1
2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Groundsmaster4500-D
Groundsmaster Traction Unit
Model No. 30856—Serial No. 230000701 and Up
Form No. 3350–720
CE Compliance Set Up Instructions
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total setup cannot be completed. Some parts may have already been assembled at the factory.
Description Qty. Use
Throttle stop
Set screw 1 1Install for CE compliance
Lift latch
Latch bracket –R.H.
Latch bracket –L.H.
Flange lock nut 1/4–20
1
1
1
2
Install on control console for CE compliance
Lock bracket
Screw 1/4–20 x 1/2”
Washer .281 x .625
Lock nut 1/4–20
1
1
1
1
Install on hood latch for CE compliance
EEC decals 2Apply to machine for CE compliance.
EEC certificate 2
Install Throttle Stop
1. Loosen set screw on throttle stop.
2. Slide throttle stop onto high idle stop screw (Fig. 1).
Slot in throttle stop to be positioned over rib on engine.
3. Start engine and allow to run for 5 to 10 minutes. The
temperature gauge needle should be in the yellow
before proceeding to next step.
4. If cutting units are equipped with standard angled sail
blades, adjust high idle to 2575 rpm with the cutting
units disengaged. If equipped with high lift parallel sail
blades, adjust high idle to 2550 rpm with the cutting
units disengaged.
5. Tighten setscrew. Apply adhesive into setscrew to
prevent tampering.
1
2
Figure 1
1. Throttle stop 2. Set screw

2
Install Cutting Unit Lift Latch
1. Rotate latches and remove control panel cover (Fig. 2).
1
4
3
5
2
Figure 2
1. Operators control panel
2. Capscrews
3. L.H. latch bracket
4. R.H. latch bracket
5. Lift latch
2. Under front of control panel, locate ends of capscrews
securing control panel to frame (Fig. 2).
3. Insert left hand latch bracket up thru lift lever slot and
onto capscrew. Loosely secure with 1/4–20 flange nut
(Fig. 2).
4. Insert right hand latch bracket up thru lift lever slot and
onto capscrew. Loosely secure with 1/4–20 flange nut
(Fig. 2).
5. On top of control panel, insert each end tab of lift latch
into holes in latch brackets (Fig. 2). Tighten flange nuts.
Installing the Hood Latch
1. Unhook the hood latch from the hood latch bracket
(Fig. 3).
2. Slide the hood lock bracket onto the latch (Fig. 3).
3. Hook the latch onto the hood latch bracket (Fig. 3).
4. Insert a bolt (1/4 x 1-1/2 in.) through the hood lock
bracket and secure it with a flat washer and locknut
(Fig. 3).
1
2
3
Figure 3
1. Hood latch
2. Hood latch bracket 3. Hood lock bracket