TP-Link TL-SF1005D User manual

User Guide
TL-SF1005D
TL-SF1008D
TL-SF1016D
10/100Mbps Desktop Switch
7106504962 REV 4.0.0
Downloaded from ManualsNet.com search engine

1
FCC STATEMENT
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received,
including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment.
CE Mark Warning
This is a class B product. In a domestic environment, this
product may cause radio interference, in which case the
user may be required to take adequate measures.
Package Contents
The following items should be found in your box:
One TL-SF1005D/TL-SF1008D/TL-SF1016D Switch
One Power Adapter
This User Guide
Note:
The wall-mounting screws are not provided. Please
contact your distributor if any of the listed items are
damaged or missing.
Downloaded from ManualsNet.com search engine

2
The Switch mentioned in this User Guide stands for TL-
SF1005D/TL-SF1008D/TL-SF1016D 10/100Mbps Desktop
Switch without any explanation. For Simplicity, we will take
TL-SF1016D for example throughout this Guide.
TL-SF1016D can be mounted on a wall.
Refer to the steps below to mount the Switch on a Wall.
1. Drill two holes into the wall. Insert a screw into each
hole and leave a part of its head exposed.
2. Place the two wall-mounting slots over the screws and
slide the Switch down to fasten it.
Note: Without slots on the bottom, TL-SF1005D or TL-
SF1008D cannot be mounted on a wall.
Downloaded from ManualsNet.com search engine

3
The Switch's LEDs are located on the front panel:
LED
Status
Indication
Power
On
The switch is powered on.
Off
No Power Source.
*Please check if the power cord
is connected to the Switch
properly, and make sure the
power is ON.
Ethernet
LED
On
The corresponding ethernet
port is connected to a network
device.
Flashing
Data is being transmitted or
received.
Off
No device is connected to the
corresponding port.
*Please check if the cable
connectors are firmly plugged
into the switch and the device,
and verify that the connected
device is turned on and working
well.
COPYRIGHT & TRADEMARKS
is a registered trademark of TP-LINK
TECHNOLOGIES CO., LTD. Other brands and product
names are trademarks or registered trademarks of their
respective holders.
Copyright © 2014 TP-LINK TECHNOLOGIES CO., LTD.
All rights reserved.
http://www.tp-link.com
Downloaded from ManualsNet.com search engine