Frequently Asked Questions (FAQ)
The Power LED should be lit when the power system is working
normally. If the Power LED is not lit, please check as follows:
A1:
Make sure the power cord is connected to the switch with power
source properly.
A2:
Make sure the voltage of the power supply meets the
requirements of the input voltage of the switch.
A3: Make sure the power source is ON.
Q1. The Power LED is not lit.
It is recommended that you check the following items:
A1:
Make sure that the cable connectors are rmly plugged into the
switch and the device.
A2
:
Make sure the connected device is turned on and working well.
A3
:
The cable must be less than 100 meters long (328 feet).
Q2. The Link/Act LED is not lit when a device is
connected to the corresponding port.
Operating Temperature
Operating Humidity
Storage Humidity
0˚C to 40˚C (32˚F to 104˚F)
10% to 90%RH non-condensing
5% to 90%RH non-condensing
Environmental and Physical Specications
Specications
IEEE 802.3, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x
CSMA/CD
5/8/16/24 10/100 Mbps Auto-Negotiation RJ45 Ports
10BASE-T: UTP category 3, 4, 5 cable (≤100 m)
EIA/TIA-568 100Ω STP (≤100 m)
100BASE-TX: UTP category 5, 5e cable (≤100 m)
EIA/TIA-568 100Ω STP (≤100 m)
Power, Link/Act LEDs
Ethernet: 10 Mbps (Half Duplex), 20 Mbps (Full Duplex)
Fast Ethernet: 100 Mbps (Half Duplex), 200 Mbps (Full
Duplex)
Store-and-Forward
Automatically learning, automatically aging
10Base-T: 14881 pps/Port
100Base-Tx: 148810 pps/Port
Standard
Protocol
Interface
Network Media (Cable)
LED Indicators
Data Transfer Rate
Transfer Method
MAC Address Learning
Frame Forward Rate
General Specications
Wall Mountable
Distance Between
Mounting Holes
TL-SF1016D: 157.2 mm
TL-SF1024M: 178 mm
TL-SF1005D, TL-SF1008D: No
TL-SF1016D, TL-SF1024M: Yes
For technical support and other information, please visit
https://www.tp-link.com/support, or simply scan the
QR code.
If you have any suggestions or needs on the product
To ask questions, find answers, and communicate with TP-Link users or
engineers, please visit https://community.tp-link.com to join TP-Link
Community.
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and
other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC, 2011/65/EU
and (EU)2015/863.
The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce.
Safety Information
Use only power supplies which are provided by manufacturer and in the origin packing
of this product. If you have any questions, please don’t hesitate to contact us.
Do not use any other chargers than those recommended.
Keep the device away from water, re, humidity or hot environments.
Adapter shall be installed near the equipment and shall be easily accessible.
Do not use damaged charger or USB cable to charge the device.
Do not attempt to disassemble, repair, or modify the device. If you need service, please
contact us.
Place the device with its bottom surface downward.
