Traceable LOLLIPOP 4371 User manual

SPECIFICATIONS
Range: –50 to 300°C,
–58 to 572°F
Resolution: 0.1° from –20 to 200°,
1° outside this range
ULTRA™ THERMOMETER ACCURACY
Ultra™ thermometers are tested at
selected test points to be within tighter
than normal tolerances to assist in
providing improved accuracy. Other
points will not necessarily fall within
accuracy as those found at selected test
points, but will be within an accuracy of
±1.0°C.
FEATURES
• Waterproof and shockproof
• Stainless steel sensor probe
• Max/Min memory recall
• °F/°C selectable
• One second sampling rate
• Protective plastic sleeve
with clip and holder
• Low battery indicator
OPERATION
Remove Lollipop™ thermometer from
the protective sheath. Press ON/OFF
button to activate. Press °F/°C button to
switch between Fahrenheit and Celsius
temperature. Insert probe into the material
to be measured and read display.
MAX/MIN MEMORY
To view the minimum temperature
reached since activating unit, press
MAX/MIN button. “MIN” appears on
the display to indicate the minimum
temperature recorded. Press MAX/
MIN button a second time within
3 seconds to view the maximum
temperature reached since activating
unit. “MAX” appears on the display
to indicate the maximum temperature
recorded.
NOTE:
Three seconds after pressing
the MAX/MIN button, the unit
automatically returns to current
sampling mode. Indicators “MIN”
and “MAX” are no longer displayed.
Turn the unit OFF to reset max/min to
current temperature.
www.GlobalTestSupply.com
Find Quality Products Online at: [e-mail]

TRACEABLE
LOLLIPOP
WATERPROOF/
SHOCKPROOF
THERMOMETER
INSTRUCTIONS
ALL OPERATIONAL DIFFICULTIES
If this thermometer does not
function properly for any reason,
please replace the battery with a new
high quality battery (see “Battery
Replacement” section). Low battery
power can occasionally cause any
number of “apparent” operational
difficulties. Replacing the battery with
a new fresh battery will solve most
difficulties.
BATTERY REPLACEMENT
Erratic readings, faint readings or no
display are all indications that the
battery must be replaced. Using a
screwdriver, unscrew the three screws
located on the battery cover on back
of the unit. Remove the exhausted
battery and replace with a new
battery. Make certain the positive (+)
side is facing you. Equivalent battery
replacements are: RAYOVAC RW42,
DURACELL D357, and EVEREADY
357. Replace the battery cover. Screw
the three screws back into the unit.
Do not over-tighten the screws as this
may cause damage to the battery
cover.
®
™
©2019 Traceable®Products. 92-4371-00 Rev. 8 100419
Traceable®and Ultra™are registered trademarks/trademarks of
Cole-Parmer.
www.GlobalTestSupply.com
Find Quality Products Online at: [e-mail]