Traceable 4351 User manual

TRACEABLE
KEY-CHAIN
THERMOMETER
INSTRUCTIONS
BATTERY REPLACEMENT
Erratic readings, a faint display, or no display
are all indications that the battery is low and
needs to be replaced. To replace the battery,
remove the battery cap, located on the top
of the unit and marked open, by turning it in
the direction of the arrow (counterclockwise).
Remove the battery and insert a new Cat. No.
1039 battery. Make certain that the positive
(+) side is facing you. Incorrectly installed
batteries may damage electronics. Replace
the Battery Cap.
ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function properly
for any reason, please replace the battery
with a new high quality battery (see “Battery
Replacement” section). Low battery power
can occasionally cause any number of “ap-
parent” operational difficulties. Replacing
the battery with a new fresh battery will solve
most difficulties.
®
Traceable®is a registered trademark of Control Company.
©2016 Control Company. 92-4337-00 Rev. 2 061716
www. .com [e-mail]1.800.561.8187

SPECIFICATIONS
Range: –58 to 302°F
(–50 to 150°C)
Resolution: ±0.1° from –20.0 to
200.0°, 1° below –20.0
and above 200.0°
Accuracy: ±1.0°C between
–20.0 and 100°C
Sampling rate: 1 second in
Celsius mode
10 seconds in
Fahrenheit mode
Battery: Cat. No. 1039
Construction: Stainless steel
and plastic
OPERATION
1. Slide the ON/OFF switch
(3, Fig. 1) to ON to turn the
unit on.
2. Slide the °C/°F switch
(1, Fig. 1) to °F to display the
temperature in Fahrenheit or to
°C to display in Celsius.
3. Insert the stem into air,
semi-solid, or liquid material to
be measured.
4. Slide the ON/OFF switch
(3, Fig. 1) to OFF to turn the
unit off. To conserve battery
life, always turn the unit off
when not in use.
Figure 1.
1 2 3
Description
1 - °C/°F Switch
2 - Display
3- ON/OFF Switch
www. .com [e-mail]1.800.561.8187