Transmille 3000 Series User manual

Operation Manual
3000 SERIES VIRTUAL FRONT PANEL
Application Note V2.00
3000 Series VFP Instructions.doc
Calibrator Options & Settings
To set the installed options for the 3000 Series calibrator, select the general set-up function using the virtual
front panel, shown below :

Operation Manual
3000 SERIES VIRTUAL FRONT PANEL
Application Note V2.00
3000 Series VFP Instructions.doc
Once the options and setting screen is shown, the options installed can be selected and saved back to the
calibrator. To apply these settings, press the Save & Exit button
NOTE : To allow new options setting to be loaded by calibrator, please turn
calibrator off, then on again after saving new option settings.
NOTE : All of the options require specific hardware to be installed in the
calibrator. Selecting the option in the firmware will not allow this option to be
used unless the hardware is fitted.
Set options as required using
checkboxes, then click Save &
Exit to apply.