Travis Industries 564 LedgeStone User manual

564 LedgeStone Fireback Installation
96100191
Page 1 of 3 17601845 - 4/2/14 Travis Industries, Inc.
Compatibility
564 SS
564 HO with Ember-Fyre or Dancing-Fyre Burner Only
Packing List
Rear Fireback
(2) Side Firebacks
Fireback Floor (steel) – Used for 564 HO with Ember-Fyre Burner Only
Fireback Orientation – Each Side Has a Notch in the Upper Front Corner
Make sure the firebacks are oriented as shown below (the grout lines and coloring will line
up). The side firebacks have notches in the front upper corners. Arrange the firebacks
before installing to verify alignment.
Note how these notches fit with the adjoining fireback.
Fireback Floor– Used on 564 HO with Ember-Fyre Burner Only
The 564 HO is shipped without a burner or fireback floor. Follow the instructions included with the Ember-Fyre burner to
install the firebox components. When the instructions call for installation of the firebacks, install the fireback floor directly
on the base of the firebox. Then install the ledgestone firebacks on top of the fireback floor (see instructions on following
pages).
Using the LedgeStone Firebacks with 564 HO and the Dancing-Fyre Burner Only
The 564 HO is shipped without a burner or fireback floor. The Dancing-Fyre Burner includes steel firebacks (including the
fireback floor), Follow the instructions included with the Dancing-Fyre burner to install the firebox components. When the
instructions call for installation of the firebacks, install the fireback floor (either the one included with this kit or the burner)
directly on the base of the firebox. The steel firebacks sides may be discarded. Then install the ledgestone firebacks on
top of the fireback floor (see instructions on the following pages).

564 LedgeStone Fireback Installation
96100191
Page 2 of 3 17601845 - 4/2/14 Travis Industries, Inc.
Installation
WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
SPECIAL INSTRUCTIONS FOR 564 HO – EXHAUST BAFFLE
The 564 HO has an exhaust baffle that must be removed before placing the rear fireback. Remove the baffle following the
instructions below. After the firebacks are in place, replace the baffle (the rear screws may be kept loose).
Back Wall of Firebox
Firebox Roof
Use a 1/4" nutdriver (with
extension) to loosen the
back screws 2 turns.
1/4”
Socket
a
While supporting the exhaust baffle,
remove the two front screws
b
Slide the exhaust baffle
forward and remove
from the firebox.
c
Exhaust Baffle
1/4" Nutdriver

564 LedgeStone Fireback Installation
96100191
Page 3 of 3 17601845 - 4/2/14 Travis Industries, Inc.
Installation (continued)
1 Remove the glass frame and logs (see the installation manual for details).
2 Install the firebacks following the directions below.
Place the rear fireback in place. The side
fireback holds the rear fireback in place -
hold the rear fireback while installing the
side fireback.
Remove the clips located on the
firebox ceiling near the front (both
sides). These clips have keyhole
slots that allow removal by
loosening the screw and sliding
the clip out.
Place the side firebacks
in place.
a































1/4" Nutdriver
































c
Replace the clips removed in
step “a” to secure the side
firebacks..
d
HINT: Hold the firebakcs
at an angle and pivot them
into place while installing.
NOTE:
The firebacks install on top
of the fireback floor.
b
3 Restore the fireplace to the correct configuration.