Treedental TR-DPM03 User manual

TR-DPM03
Free Fog Mirror User Manual

1. Component Introduction
1.Matching four reflectors with different roles.
2.It is made of 8K mirror 304 stainless steel material, stamping process and highly polished finish.
3.The reflector is uniquely designed by experienced clinical experts, and the turning angle
distance at the back has been repeatedly demonstrated.
4.It conforms to the Asian’s design, and can fully open the soft tissues of the cheeks at the back
of the mouth, so that the joints can be photographed completely and clearly.
5.The reflector is connected to the host with a plug-in design.
6.The main unit has the functions of blowing and defogging and light-assisted focusing, So that
when the reflector enters the mouth, it will not fog up due to temperature difference or
breathing.
7.At the same time, there are enough LED light sources to allow the photography equipment to
successfully focus.

2. Host parameters
It is powered by a lithium battery, and the charging voltage is 5V. In the charging process, the red
light, full, green light, charging time of about 2-3 hours.
3. Description of the buttons on the main unit
1.The right button of the main unit is the air
blowing and LED light source switch, lightly
press to turn on the air blowing and LED light
source, press again to turn off the air blowing
and light source;
2.The left ight button is the air blowing
switch, lightly press to turn on the air blowing,
and then click to turn off blowing.

4. Usage and precautions
1.Using a pulling hook to pull the corners of the mouth apart
2.The reflector is placed on the pin position of the host.
3.Turn on the blower and light buttons.
4.The reflector rotates into the mouth.
5.Pay attention to the position of the reflector, don’t lift up and touch the teeth to be
photographed
6.The shooting is completed when the subject's mouth is at its maximum.
7.The host will automatically shut down after working for 2 minutes. The purpose is to prevent
the lights from overheating and reduce battery consumption.
5. Disinfection
After using the reflector, do not mix with other instruments to clean Please prevent it from being
placed in a dedicated sterilization box in time.(Special disinfection boxes need to be purchased
additionally.)
When cleaning, use soft gauze or clean with bare hands, and stick a little cleaning fluid to remove
the grease remaining after hand contact.

Then rinse with clean water and blow dry in time with an air gun.
Drying is not recommended, because moisture will leave marks and corrode the mirror surface.
6. Storage
Store in a cool and dry place. If it is not used for a long time, please place it in a dry environment.