TREND XCITE/BBC User manual

XCITE/BBC Installation Instructions TG200686 Issue 2 , 05-Jun-2014 1
Installation Instructions - Mounting
XCITE/BBC
IQ3xcite Battery Option Board
Important: Retain these instructions
These instructions shall be used by trained service personnel only
If the equipment is used in a manner not specied by these instructions, the protection provided by the equipment may be impaired.
1Switch off 2Isolate I/O
3Open Panel 4Remove Auxiliary Board Cover
3 INSTALLATION
1 BOX CONTENTS 2 STORING
CONTENTS
1 Box contents ..................................................................1
2 Storing ...........................................................................1
XCITE/BBC Installation
Instructions (TG200686)
3 Installation .....................................................................1
4 Disposal .........................................................................2
HO
2
+70 °C
(158 °F)
0
-10 °C
(-14 °F)
95 %RH
WARNING: The connecting leads may be
connected to supplies. Isolate before touching.
also isolate any
I/O modules


WARNING:Opening the panel may
expose dangerous voltages.
417-IEC-5036

2 XCITE/BBC Installation Instructions TG200686 Issue 2 , 05-Jun-2014
XCITE/BBC Installation Instructions - Mounting
Please send any comments about this or any other Trend technical publication to [email protected]
© 2014 Honeywell Technologies Sàrl, ECC Division. All rights reserved. Manufactured for and on behalf of the Environmental and Combustion Controls
Division of Honeywell Technologies Sàrl, Z.A. La Pièce, 16, 1180 Rolle, Switzerland by its Authorized Representative, Trend Control Systems Limited.
Trend Control Systems Limited reserves the right to revise this publication from time to time and make changes to the content hereof without obligation
to notify any person of such revisions or changes.
Trend Control Systems Limited
Albery House, Springeld Road, Horsham, West Sussex, RH12 2PQ, UK. Tel:[phone] Fax:[phone] www.trendcontrols.com
Trend Control Systems USA
6670 185th Avenue NE, Redmond, Washington 98052, USA. Tel:[phone] Fax:[phone] www.trend-americas.com
5Plug in Battery Board
6Insert Battery
7Replace Auxillary Board Cover 8Close Panel
9Reconnect Supply to I/O 10 Switch On
3 INSTALLATION (continued)
4 DISPOSAL
WEEE Directive:
At the end of their useful life the packaging and
product should be disposed of by a suitable
recycling centre.
Do not dispose of with normal household waste.
Do not burn.




also reconnect any I/O modules


Warning: The lithium battery must not be
recharged, disassembled, burnt or short
circuited. Misuse may cause explosion or
re. Dispose of carefully. Refer to Health and
Safety Executive Guidance Note GS43 - see
section 4, Disposal, below.

CR 2032
CR 2032
apply plate apply board to plate press board home
plate supplied with XCITE/BBC
CR2032 3V supplied with XCITE/BBC