Triton Satellites CYRENE User manual

Installers please note these InstructIons are to be left wIth the user
2180529A September 2006
Installation
instructions
CYRENE
Fixed showerhead
kit
Part 2: Kit

CONTENTS Page
General installation notes 1
Main components 2
Installing the ceiling arm 3
Spare parts 5
Guarantee, etc. rear cover
To check the product suitability for commercial and multiple installations, please contact
Triton’s specification advisory service before installation.
Telephone: [phone]
Facsimile: 0870 067 3334
E mail: [e-mail]

1
The following notes are given as the
suggested steps for installing the Satellites
mixer shower and remote control:
1. Site survey
Determine the position of all parts of
the shower (kit, mixing unit and control)
before starting the installation.
2. Fit the mixing unit
3. Install the shower kit
Having determined the position of the
mixing unit install the shower kit.
4. Install the pipework and plumbing
Run the pipework from the mixing unit to
the shower kit outlet. Connect the inlet
pipework, outlet pipework and then the
outlet fittings.
5. Electrical connections
Connect the mixing unit to the electrical
supplies.
6. Register the remote control panel
Register the control panel to the mixing
unit.
7. Commission the unit
Commission the shower and select the
desired feature settings.
8. Fit the control panel to the wall
Install the remote control panel wall
mounting bracket within the showering
area. Fit the control panel onto the
bracket.
9. Operation
Operate the shower and set preferred
flow settings.
GENERAL INSTALLATION NOTES
A video detailing the installation of the
Satellites mixer shower can be seen at
www.tritonshowers.co.uk.
A DVD is also available on request.
Contact the Brochure request line for
details on
024 7632 4460

2
Fig.1 MAIN COMPONENTS
Cyrene ceiling arm kit (Fig.1)
1. Ceiling arm mounting plate
2. Olive
3. Locking nut
4. Ceiling trim
5. Ceiling arm
6. Emily fixed showerhead
7. Fixing screws and wall plugs
(not shown)
Instructions, guarantee, template etc.
1
2
3
4
5
6

3
INSTALLATION
IMPORTANT: Make sure all pipework
connections to and from the mixing unit
have been completed before connecting to
the outlet. Refer to ‘Part 3: Mixing unit for
details.
Decide the position for the ceiling arm on
the ceiling within the shower area.
Position the mounting plate on the ceiling.
Mark the centre hole and the four securing
holes on the ceiling (fig.2). Using a 26 mm
cutter, drill the ceiling opening.
Note: The installer may wish to consider
building a support (fig.3) or similar within
the loft space to provide extra support for
the ceiling arm and associated pipework.
Insert the mounting plate onto the opening
and secure using the screws supplied.
Plumbing connections
Complete the outlet pipework running from
the mixing unit into the top of the mounting
plate and finish the installation using an
olive and a 15 mm connector (fig.4).
IMPORTANT: Before completing the
connection of the water supply to the
ceiling arm flush out the pipework to
remove all swarf and system debris.
Joist
Plasterboard
Support
32 mm diameter
opening in support
Fig.3
WARNING!
The edges of the riser rail
are extremely sharp. Take
care when handling and
cutting the rails.
Fig.2
15 mm
incoming
pipework 15 mm connector
Olive
Mounting
plate
Support
Plasterboard
ceiling
Fig.4

4
Fitting the ceiling arm
Wrap the exposed thread on the mounting
plate with PTFE tape.
Slide the locking nut and olive onto the
ceiling arm. Insert the ceiling arm into the
mounting plate and slide the olive up to the
plate base. Screw the locking nut onto the
mounting plate and tighten to secure the
ceiling arm in position (fig.5).
Slide the ceiling trim over the arm up to the
ceiling and push fit onto the mounting plate
(fig.6).
Screw the fixed showerhead to the arm,
making sure the supplied washer is in place
(fig.7).
Mounting
plate
Olive
Locking nut
Ceiling arm
Fig.5
)L[HGKHDG
&HLOLQJDUP
:DVKHU
Fig.7
Mounting
plate
Ceiling trim
Fig.6

5
Ref. Description Part No.
1. Mounting plate 83310900
2. 19 mm olive 83310910
3. Locking nut 83310920
4. Ceiling trim 83310930
5. Ceiling arm 83310940
6. Emily fixed showerhead 88600006
SPARE PARTS
1
2
3
4
5
6

Triton Showers
Triton Road
Nuneaton
Warwickshire CV11 4NR
Triton is a division of Norcros Group (Holdings) Limited
Customer Service: % 0870 067 3333
Scottish and Northern Ireland
Customer Service: % 0845 762 6591
Trade Installer Hotline: % 0870 067 3767
Fax:
0870 067 3334
www.tritonshowers.co.uk
E mail: [email protected]
TRITON reserve the right to change product specification without prior notice. E&OA. © TRITON SHOWERS 2008
TRITON STANDARD GUARANTEE
Triton guarantee this product against defects arising from faulty workmanship or materials for a period of
one year for domestic use only, from the date of purchase, provided that it has been installed by a competent
person in full accordance with the fitting instructions.
Any part found to be defective during this guarantee period we undertake to repair or replace at our option
without charge so long as it has been properly maintained and operated in accordance with the operating
instructions, and has not been subject to misuse or damage.
This product must not be taken apart, modified or repaired except by a person authorised by Triton.
This guarantee applies only to products installed within the United Kingdom and does not apply to products
used commercially. This guarantee does not affect your statutory rights.

Check out our full range of Showers
Electric Showers
Digital Showers
Mixer Showers
Power Showers
Smart Showers
Shower Towers
From Top Shower Brands
Mira Showers
Aqualisa Showers
Triton Showers
Gainsborough Showers
Shower Pumps can upgrade your showering experience even more
Stuart Turner Shower Pumps
Salamander Shower Pumps
Grundfos Shower Pumps