Triton TRADITIONAL User manual

2181171C - May 2021
INSTALLERS PLEASE NOTE THESE INSTRUCTIONS ARE TO BE LEFT WITH THE USER
TRITON ALWAYS RECOMMEND THE USE OF GENUINE TRITON ACCESSORIES
FOR USE WITH A TRITON SHOWER. FAILURE TO USE GENUINE TRITON PARTS
MAY INVALIDATE YOUR GUARANTEE.
All dimensions are approximate.
78mm
222mm
72mm
TRADITIONAL
single position
shower head
SAFETY RECOMMENDED TRITON ACCESSORY

Always use genuine Triton accessories.
When tting your new shower head, please
ensure that the installation complies with water
regulations.
INSTALLATION
Flush the hose through to remove any debris
that may be in the system.
Before installing the shower head check the
condition of the hose; if damaged, please
replace.
Feed the hose through the hose retainer or the
hole in the soapdish.
IMPORTANT: It is the conical end of the hose
which grips into the holder. The shower head
will not t in the holder without the hose
attached.
CLEANING THE SHOWER HEAD
It is important to keep your shower head clean
to maintain the performance of your shower.
Triton recommends that all products are
cleaned using warm, soapy water.
DO NOT use abrasive or aggressive chemical
cleaning products as this may affect the product
surface and finish and invalidate your guarantee.
The shower head can be cleaned quickly by
simply rubbing your fingers over the spray plate.
IT IS IMPORTANT TO KEEP THE SHOWER
HEAD CLEAN TO MAINTAIN THE
PERFORMANCE OF THE SHOWER. The
hardness of the water will determine the
frequency of cleaning. For example, if the
shower is used every day in a very hard water
area, it may be necessary to clean the shower
head on a weekly basis.
NOTE: This shower head is not designed to be
disassembled.
Flats
Fig.1
TRADITIONAL FIXED SHOWER
HEAD REPLACEMENT CODE
TSHMTRAD1CH
For latest service policy and contact details visit www.tritonshowers.co.uk
Installation & Maintenance InstructionsInstallation & Maintenance Instructions
NOT FOR USE ON
ELECTRIC SHOWERS