Aria 3 Position Shower Head
INSTALLATION
Before installing the shower head, flush the
pipework through to remove any debris that
may be in the system.
CLEANING
Triton recommends that all products are
cleaned using warm, soapy water.
DO NOT use abrasive or aggressive chemical
cleaning products as this may affect the
product surface and finish.
NOTE: Before cleaning, turn off the unit at
the mains supply to avoid the shower being
accidentally switched on. The shower head may
be cleaned by simply rubbing your thumb over
the spray plate.
IT IS IMPORTANT TO KEEP THE SHOWER
HEAD CLEAN TO MAINTAIN THE
PERFORMANCE OF THE SHOWER. The
hardness of the water will determine the
frequency of cleaning. For example, if the
shower is used every day in a very hard water
area, it may be necessary to clean the shower
head on a weekly basis.
SHOWER HEAD
Fitting the correct type of shower head
is critical to the safe performance of your
shower, especially if you have an electric
shower. Some shower heads are only
suitable for use on mixer showers as
the ow of water from them can be
restricted or stopped completely, which
can result in a build-up of potential hot
water which could, under pressure, be
unexpectedly released.
You can therefore, rest assured when you
order a genuine Triton electric
shower head that it has been fully tested
for use in the UK on all electric shower
types.
INSPECTING THE HOSE
Your shower hose should be inspected
from time to time for signs of damage or
internal collapse.
Internal collapse can restrict the ow
rate from the shower head and may
cause damage to the shower, especially
an electric shower.
Triton recommends use of a branded
anti-twist hose on all showers to
ensure continuous safe performance.
To inspect your hose:
1. Unscrew the hose from the shower head
and the shower outlet.
2. Inspect the hose for damage, internal
kinks, etc.
3. If necessary, replace the hose.
