Truma Combi CP Plus User manual

Select energy mode
Truma Combi®
Quick Reference
CP Plus Functions
Adjust room temperature - Range: 40-86°F (5-30°C)
a) LP gas
b) MIX 1* - Electricity 850W + Gas
c) MIX 2* - Electricity 1700W + Gas
d) EL* - Electricity 850W
e) EL* - Electricity 1700W
a) boiler –Hot water generator is on. Icon
flashes until desired temperature is reached.
b) eco –Water temperature is 104°F (40° C)
c) hot –Water temperature is 140°F (60° C)
d) boost –Boiler content is heated quickly
(boiler priority) for up to 40 minutes. The water
temperature is then kept at the higher level
(about 144° F (62° C) for two subsequent
heating cycles. When the water temperature is
reached, the room is heated again.
Adjust water temperature
*Truma Combi eco plus and comfort plus
only

Truma Combi®
Quick Reference
CP Plus Functions –Cont.
Select fan speed
OFF –Fan is switched off (If furnace mode OFF)
a) VENT - Circulating air (If furnace mode OFF)
b) ECO - Low fan speed
c) HIGH –High fan speed
d) BOOST –Fast room heating. Available if the
difference between the selected and current
room temperature is >18° F (10° C)
Set clock to current time
Set time switch
Set a start time and end time for room temperature,
water temperature, energy mode and fan speed set
points.
Settings
Index - Show version number of connected device
Bright - Adjust backlighting
Lang - Adjust language
12-24h - 12/24 hour mode
Temp –°F or °C
Offset –Calibrate temp offset
Pr set –Factory reset