Tsun TSOL-MS400 Original operating instructions

Installation Steps
Step 1. Make an installation map
DANGER
CAUTION
MICROINVERTER
Quick Installation
When choosing the position of installation, comply with the following
conditions:
Take out the SN labels and installation map from the package. Paste
the SN labels on the installation map as below and complete the
information of the solar plant.
TSOL- MS400/MS350/MS300 TSOL- MS800/MS700/MS600
Choose an installation position. Using two pairs of screws and nuts
microin
AC cables.
branch circuit.
connector to be closed.
sunlight.
may be present.
·
correct operation of electronic equipment.
G3
clearances.
incorrect installation and operation may lead to serious safety and
shock hazards or equipment damage.
Be aware that installation of this equipment includes risk of electric
shock.
·If there are more than one installation site, please make the
installation site.
The direction on the upper left corner means the actual installation
orientation.
DANGER
WARNING
CAUTION
and humid.
·There are no screws and nuts in the package.
length of AC cables. The length of AC cables are shown as below:
WARNING
Model
Model Quantities for each cable section
2 / 2 / 3
5 / 6 / 7
11 / 13 / 15
Cable Length
2.5 m
1.4 m
TSOL-MS800/MS700/MS600
TSOL-MS400/MS350/MS300
TSOL- MS1600/MS1800/MS2000
2.5 m
TSOL-MS1600/MS1800/MS2000
Step 3. Connect the ground cable
WARNING
·Ensure that all
·Use φ6 screw for .
Step 4. Connect the AC cable of two microinveers
TSOL-MS800/MS700/MS600
TSOL-MS400/MS350/MS300
TSOL-MS2000/MS1800/MS1600

Separate the AC connector as shown below.
Get the AC cable through the shell of AC connecter and connect
Reassemble the AC connector. Plug it into the microinveer and
connect the AC cable to the AC distribution box.
a two-minute wait time.
is shown as below.
Install the PV modules and connect the DC cable to the microin-
connectors in the module side of DC extension cable.
circuit(s) until you have completed all the installation procedures and
have received prior approval from the electrical utility company.
·Ensure that all DC cables are correctly wired and that none of the
wires are pinched or damaged.
may be energized.
Working normally
Working abnormally
Fault
Fishing Green (0.2-3.8)
Fishing Red
Solid Red
from the system.
disconnected from the home distribution network and the AC breaker
is open.
·Ensure that all AC cables are correctly wired and that none of the
wires are pinched or damaged.
·The installation technician is responsible for selecting a kind of AC
distribution network correctly.
L: Live
N: Neutral
PE: Ground
Talent Home
Download and install it in the mobile phone.
Talent Home
Follow the user guidance and complete all the operations in
the App.
TSUNESS Co,. Ltd
E-MAIL : [email protected]
WEB : www.tsun-ess.com
TEL : [phone]
11061400102 V1.2
Step 8. Download the monitoring App
Step 5. Connect AC end cable Step 6. Connect DC cable
Step 7. Sta the system
Fishing Green (0.2-0.8)
WiFi disconnected
·The AC connector and protection cap is not in the package.