Tsun TSOL-ESK350-E User manual

Quick Installation Guide
CAUTION
WARNING
CAUTION
TSOL-ESK350/400/800/1600-E
Step 1. Find a suitable location
Step 2. Open the solar panel lock
Step 4. Adjust the direction and angle
Step 3. Prop up the bracket
Step 5. Install the Expansion Kit
(For ESK800 & ESK1600)
Open the package and pick up the Easy Solar Kit by the notches around
the base plate. Find a suitable location and put down the Easy Solar Kit
lightly.
There are two solar panel locks on the base plate. Use a screwdriver to
screw off the solar panel locks.
There are two angle locks on the bracket. Adjust these two angle locks
at the same time.
Pick up the base plate and adjust the direction. Make the solar panel
facing the sun light.
Use DC Extend Cable to connect the Expansion Kit to the ESK800 or
ESK1600.
Lift the solar panel by one hand and use another hand to rotate the
angle lock in counterclockwise direction. Slowly put down the solar
panel and make the angle lock slip into the right angle. Rotate the angle
lock in clockwise direction and tighten the angle lock.
Lift up the solar panel and prop up the bracket. Screw on the solar
panel locks to fix the bracket on the base plate.
TSOL-ESK800 has one Expansion Kit and TSOL-ESK1600 has three
Expansion Kits. Install the Expansion Kit according to Step 1 to Step 4.
The recommended distribution is shown as below:
Please put the Easy Solar Kit on a flat and
non-shadow location.
The bracket must be fixed on the base
plate, which will promote the wind loading
rating of Easy Solar Kit.
WARNING
Pay attention to the distance between two
ESK products and make sure that there is
no shadow on the panels.
CAUTION
Please adjust the direction at noon to get a
better electric energy production during
the day time.
CAUTION Recommended angle parameters can be
found in the appendix table.
Easy Solar Kit has a 2.1m end cable and
should be set near the socket. Or use the
expansion cable as shown in Step 5.
Figure Notches around the base plate
Figure Screw on the solar panel locks
Figure Solar panel lock Figure Angle lock on the bracket
Figure The recommended distribution
01 02
Figure Adjust the angle lock
ESK800 ESK1600
Expansion
Kit
Expansion
Kit
Expansion
Kit
Expansion
Kit
03

Figure Connect the DC connector
Step 6. Extend the end cable (optional)
Extension cable (TSOL-MC200-G2, 2 m) can be used to extend the end
cable.
Dismantle the end cable.
06
el: [phone]
TSUNESS Co., Ltd
T
E-mail: [email protected] | www.tsun-ess.com
Add: Building E1, No. 555, Chuangye Road, Dayun Town, Jiashan County,
Jiaxing City, Zhejiang Province, China
Step 7. Put weights on the base plate
Step 8. Connect more Easy Solar Kit (optional)
Put weights (Brick, Stone etc.) on the base plate to promote the wind
loading rating of Easy Solar Kit.
More Easy Solar Kit can be connected together to form a whole system.
Take out the end cable of the second Easy Solar Kit. Connect the two
sides of Extension Cable to the first and second microinverter.
Step 9. Start the System
Insert the plug to the socket and the system will start producing power
after about a two-minute waiting time.
Optional accessories can be used to connect two base plates together.
Connect the two sides of extension cable to the microinverter and the
end cable.
CAUTION Weights (Brick, Stone etc.) should be more
than 20kg。
Figure Connect the extension cable
Figure weights on the base plate
Figure Connect the Extension Cable
Figure Optional accessories for the connection of base plate
Figure Dismantle the end cable
04 05