Tunturi RUN 3.0 User manual

RUN 30
English

I
Illustrations
EN
2 RUN 30

1
16
1514
3
713
7
54
4
6
3
12
11
2
10
12
11
8
9
A
E
EN
RUN 30 3

C
B
17 (2x) 19 (6x) 20 (2x)18 (2x)
M8*70 M10*60 M4*10 M10
21 (4x)
4*13
E
EN
4RUN 30

100 CM
100 CM
200 CM
100 CM
18
20
19
18
20
19
D1
D0
E
EN
RUN 30 5

D3
D2
17
17
21
21
E
EN
6RUN 30

E1
E2
E
EN
RUN 30 7

E3
F
E
EN
8RUN 30

G
P1. SPEED
P2. SPEED P3. SPEED
P4. SPEED P5. INCLINE
P6. INCLINE P7. INCLINE
P8. INCLINE P9. INCLINE
E
EN
RUN 30 9

I
H
E
EN
10 RUN 30

C
Content
TREADMILL
Welcome to the world of Tunturi Fitness!
Thank you for purchasing this piece of Tunturi equipment. Tunturi offers a wide
range of home fitness equipment, including crosstrainers, treadmills, exercise bikes,
rowers and vibration plates. The Tunturi equipment is suitable for the entire family,
no matter what fitness level. For more information, please visit our website
www.tunturi.com
Safety warnings
WARNING
– Read the safety warnings and the instructions. Failure to follow the
safety warnings and the instructions can cause personal injury or
damage to the equipment. Keep the safety warnings and the
instructions for future reference.
▪ The equipment is suitable for domestic use only. The equipment is not suitable
for commercial use.
▪ The use of this equipment by children or persons with a physical, sensory,
mental or motorial disability, or lack of experience and knowledge can give cause
to hazards. Persons responsible for their safety must give explicit instructions or
supervise the use of the equipment.
▪ Before starting your workout, consult a physician to check your health.
▪ If you experience nausea, dizziness or other abnormal symptoms, immediately
stop your workout and consult a physician.
▪ To avoid muscular pain and strain, start each workout by warming up and finish
each workout by cooling down. Remember to stretch at the end of the workout.
▪ The equipment is suitable for indoor use only. The equipment is not suitable for
outdoor use.
▪ Only use the equipment in environments with adequate ventilation. Do not use
the equipment in draughty environments in order not to catch a cold.
▪ Only use the equipment in environments with ambient temperatures between
10 °C and 35 °C. Only store the equipment in environments with ambient
temperatures between 5 °C and 45 °C.
EN
RUN 30 11

▪ Do not use or store the equipment in humid surroundings. The air humidity must
never be more than 80%.
▪ Only use the equipment for its intended purpose. Do not use the equipment for
other purposes than described in the manual.
▪ Do not use the equipment if any part is damaged or defective. If a part is
damaged or defective, contact your dealer.
▪ Keep your hands, feet and other body parts away from the moving parts.
▪ Keep your hair away from the moving parts.
▪ Wear appropriate clothing and shoes.
▪ Keep clothing, jewelry and other objects away from the moving parts.
▪ Make sure that only one person uses the equipment at a time. The equipment
must not be used by persons weighing more than 120 kg.
▪ Do not open equipment without consulting your dealer.
E
Electrical safety (only applicable for equipment with electric
power)
▪ Before use, always check that the mains voltage is the same as the voltage on
the rating plate of the equipment.
▪ Connect the equipment to a grounded wall socket. The equipment is supplied
with a grounded cable. Insert the grounded plug into a wall socket that is
properly installed and grounded in accordance with the local codes and
ordinances.
WARNING
– If you doubt whether the equipment is properly grounded, consult a
qualified electrician. Do not alter or modify the grounded plug. If the
grounded plug does not fit into the wall socket, have an appropriate
wall socket installed by a qualified electrician.
▪ Do not use an extension cable.
▪ Keep the mains cable away from heat, oil and sharp edges.
▪ Do not alter or modify the mains cable or the mains plug.
▪ Do not use the equipment if the mains cable or the mains plug is damaged or
defective. If the mains cable or the mains plug is damaged or defective, contact
your dealer.
▪ Always fully unwind the mains cable.
EN
12 RUN 30

▪ Do not run the mains cable underneath the equipment. Do not run the mains
cable underneath a carpet. Do not place any objects on the mains cable.
▪ Make sure that the mains cable does not hang over the edge of a table. Make
sure that the mains cable cannot be caught accidentally or tripped over.
▪ Do not leave the equipment unattended when the mains plug is inserted into the
wall socket.
▪ Do not pull the mains cable to remove the mains plug from the wall socket.
▪ Remove the mains plug from the wall socket when the equipment is not in use,
before assembly or disassembly and before cleaning and maintenance.
Package contents (fig. B & C)
▪ The package contains the parts as shown in fig. B.
▪ The package contains the fasteners as shown in fig. C. Refer to the section
“Description”.
N
NOTE
– If a part is missing, contact your dealer.
Description (fig. A)
Your treadmill is a piece of stationary fitness equipment used to simulate walking or
running without causing excessive pressure to the joints.
1 Running belt 9 Safety key clip
2 Front handlebar 10 Safety key slot
3 Side handlebar 11 Support foot
4 Hand pulse sensor 12 Transport wheel
5 SPEED +/- button 13 Console
6 INCLINE +/- button 14 Master power switch
7 Bottle holder 15 Circuit breaker
8 Safety key 16 Mains cable connection
EN
RUN 30 13

F
Fasteners (fig. C)
17 Allen bolt (M8*70) 20 Nut (M10)
18 Allen bolt (M10*60) 21 Screw (ø4*13)
19 Screw (M4*10)  
Assembly (fig. D)
WARNING
– Assemble the equipment in the given order.
– Carry and move the equipment with at least two persons.
CAUTION
– Place the equipment on a firm, level surface.
– Place the equipment on a protective base to prevent damage to the
floor surface.
– Allow at least 200 cm of clearance behind the equipment, 100 cm in
front of the equipment and 100 cm on the sides of the equipment.
▪ Refer to the illustrations for the correct assembly of the equipment.
Workouts
The workout must be suitably light, but of long duration. Aerobic exercise is based on
improving the body’s maximum oxygen uptake, which in turn improves endurance
and fitness. You should perspire, but you should not get out of breath during the
workout.
To reach and maintain a basic fitness level, exercise at least three times a week, 30
minutes at a time. Increase the number of exercise sessions to improve your fitness
level. It is worthwhile to combine regular exercise with a healthy diet. A person
committed to dieting should exercise daily, at first 30 minutes or less at a time,
gradually increasing the daily workout time to one hour. Start your workout at low
speed and low resistance to prevent the cardiovascular system from being subjected
EN
14 RUN 30

to excessive strain. As the fitness level improves, speed and resistance can be
increased gradually. The efficiency of your exercise can be measured by monitoring
your heart rate and your pulse rate.
Hold the side handlebars when stepping on the equipment. Before use, stand on the
landing rails to the left and right of the running belt. Hold the side handlebars. Do not
stand on the running belt until the running belt is operating. After use, hold the side
handlebars when stepping off the equipment. Remember to stretch at the end of the
workout.
P
Pulse rate measurement (hand pulse sensors)
The pulse rate is measured by sensors in the handlebars when the user is touching
both sensors at the same time. Accurate pulse measurement requires that the skin is
slightly moist and constantly touching the hand pulse sensors. If the skin is too dry or
too moist, the pulse rate measurement will become less accurate.
NOTE
– Do not use the hand pulse sensors in combination with a heart rate
chest belt.
– If you set a heart rate limit for your workout, an alarm will sound
when it is exceeded.
Heart rate measurement (heart rate chest belt)
The most accurate heart rate measurement is achieved with a heart rate chest belt.
The heart rate is measured by a heart rate receiver in combination with a heart rate
transmitter belt. Accurate heart measurement requires that the electrodes on the
transmitter belt are slight moist and constantly touching the skin. If the electrodes are
too dry or too moist, the heart rate measurement will become less accurate.
WARNING
– If you have a pacemaker, consult a physician before using a heart
rate chest belt.
EN
RUN 30 15

C
CAUTION
– If there are several heart rate measurement devices next to each
other, make sure that the distance between them is at least 1.5
metres.
– If there is only one heart rate receiver and several heart rate
transmitters, make sure that only one person with a transmitter is
within transmission range.
NOTE
– Do not use a heart rate chest belt in combination with the hand
pulse sensors.
– Always wear the heart rate chest belt under your clothes directly in
contact with your skin. Do not wear the heart rate chest belt above
your clothes. If you wear the heart rate chest belt above your
clothes, there will be no signal.
– If you set a heart rate limit for your workout, an alarm will sound
when it is exceeded.
– The transmitter transmits the heart rate to the console up to a
distance of 1 metre. If the electrodes are not moist, the heart rate
will not appear on the display.
– Some fibers in clothes (e.g. polyester, polyamide) create static
electricity which can prevent accurate heart rate measurement.
– Mobile phones, televisions and other electrical appliances create an
electromagnetic field which can prevent accurate heart rate
measurement.
1. Slightly moisten the electrodes on the transmitter belt with saliva or water.
2. Fasten the transmitter with the belt just below the chest, firmly enough so that
the electrodes are constantly touching the skin, but not so tight that you cannot
breathe normally.
3. Allow the electrodes to warm up properly to ensure accurate heart rate
measurement.
EN
16 RUN 30

M
Maximum heart rate (during training)
The maximum heart rate is the highest heart rate a person can safely achieve
through exercise stress. The following formula is used to calculate the average
maximum heart rate: 220 - AGE. The maximum heart rate varies from person to
person.
WARNING
– Make sure that you do not exceed your maximum heart rate during
your workout. If you belong to a risk group, consult a physician.
Category Heart rate zone Explanation
Beginner 50-60% of maximum heart
rate
Suitable for beginners, weight-watchers,
convalescents and persons who have
not exercised for a long time. Exercise at
least three times a week, 30 minutes at a
time.
Advanced 60-70% of maximum heart
rate
Suitable for persons who want to
improve and maintain fitness. Exercise
at least three times a week, 30 minutes
at a time.
Expert 70-80% of maximum heart
rate
Suitable for the fittest of persons who are
used to long-endurance workouts.
Use
Unfolding and folding the equipment (fig. E)
The equipment can be unfolded for use (fig. E1) and folded for transport and storage
(fig. E2). Refer to the illustrations for the correct way of unfolding and folding the
equipment.
Master power switch
The equipment is equipped with a master power switch to shut down the equipment
completely.
EN
RUN 30 17

T
To start the equipment:
1. Insert the mains plug into the equipment.
2. Insert the mains plug into the wall socket.
3. Set the master power switch to the on position.
To stop the equipment:
1. Set the mains power switch to the off position.
2. Remove the mains plug from the wall socket.
3. Remove the mains plug from the equipment.
Safety key (fig. F)
The equipment is equipped with a safety key that must be properly inserted into the
console to start the equipment. If you remove the safety key from the console, the
equipment will stop immediately.
1. Insert the safety key into the slot in the console.
2. Make sure that the clip of the safety key is properly attached to your clothing.
Make sure that the clip is not removed from your clothing before the safety key is
removed from the console.
Circuit breaker
The equipment is equipped with a circuit breaker that interrupts the circuit when the
electricity load is above the maximum capacity. When this occurs, the circuit breaker
must be pressed.
WARNING
– Before pressing the circuit breaker, remove the mains plug from the
equipment.
If the equipment shuts down, proceed as follows to restart the equipment:
1. Remove the mains plug from the equipment.
2. Press the circuit breaker to restart the equipment.
3. Insert the mains plug into the equipment.
Adjusting the support feet
The equipment is equipped with 4 support feet. If the equipment is not stable, the
support feet can be adjusted.
EN
18 RUN 30

1. Turn the support feet as required to put the equipment in a stable position.
2. Tighten the locknuts to lock the support feet.
Console (fig. J)
J
Pulse
ScanCal
Time
Lap
Dist
3336 24 2523
29 26 32
22
2827 31 30
38 35
37 34
22 Main display 31 Lap indicator
23 START/STOP button 32 Scan indicator
24 ENTER button 33 SPEED +/- buttons
25 MODE button 34 SPEED quick buttons
26 Mode display 35 Speed display
27 Time indicator 36 INCLINE +/- buttons
28 Distance indicator 37 INCLINE quick buttons
29 Calories indicator 38 Incline display
30 Pulse indicator
EN
RUN 30 19

C
CAUTION
– Keep the console away from direct sunlight.
– Dry the surface of the console when it is covered with drops of
sweat.
– Do not lean on the console.
– Only touch the display with the tip of your finger. Make sure that
your nails or sharp objects do not touch the display.
Explanation of buttons
Button Explanation
START/STOP Press the button to start the training. Press the button
again to pause the training (max. 4 minutes). Press the
button again to continue the training. Press and hold
the button to stop the training.
MODE Press the button to show the value for a specific item:
time, distance, calories, pulse, laps and scan (items
one after another).
ENTER Press the button to confirm your selection.
SPEED +/- buttons Press the buttons to set the speed.
SPEED quick buttons Press the buttons to set the speed to the mentioned
value.
INCLINE +/- buttons Press the buttons to set the incline.
INCLINE quick buttons Press the buttons to set the incline to the mentioned
value.
EN
20 RUN 30
NOTE
– The console switches to standby mode when the equipment is not
used for 10 minutes. To leave the energy saving mode, please press
start key for 1 second till the light turns on and then release the start
button to resume the training. All the training data will be re-started.