Twinkly Pro TWP-SW-8 User manual

USERGUIDETWP-SW-8
REV 1.200730
Smart decoration solutions for professionals

Introduction 4
Package Contents 5
Installation Requirements 6
INSTALLATION PROCESS
Connecting to the Twinkly Pro Wi-Fi Bridge 7
Connecting to a Internet Router 9
Enabling the PoE 11
13
TABLEOF CONTENTS

Thank you for choosing Twinkly Pro for your lighting needs.
This manual will provide detailed instructions, guide you through the entire
setup process, and assist you with the recommended installation procedure
for your device(s).
By reading this step-by-step guide you will:
• avoid making common installation mistakes;
• learn the technical and practical knowledge needed to operate and
manage your device(s) properly;
• minimize the need for Technical Support;
• help create the best experience possible for you and your customers.
decorate like a boss!
Sincerely,
THE TWINKLY PRO TEAM
Introduction
4

5
Package Contents
What is inside the box
1Twinkly PRO Connection Hub (Accessory for Twinkly PRO Controller 1500 ETH)
1

6
Installation Requirements
What is required for the installation *
4Ethernet Cable Extender
5Twinkly PRO Controller 1500 ETH
* purchased separately
** used to access advanced features: Multi-view Mapping and Cloud Control (WebApp)
4
5
2a
2a Twinkly PRO Wi-Fi Bridge
or
2b Internet Router**
2b

7
STEP 1 - CASE A
Connecting to the
Twinkly Pro Wi-Fi Bridge
(Access Point*)
1 2
* Refer to TWP-uWiFi user guide
NOTE - Does not support advanced features: Multi-view Mapping and WebApp

8
Connect the Ethernet Controller to the
Connection Hub using port 1 (indicated as PoE IN)
Connect the Wi-FiBridge to the Connection Hub
using port 8 (indicated as PoE OUT)
• You can also connect the Wi-Fi Bridge after
enabling the PoE
Plug the Ethernet Controller to a power source
1
2
3
PoE OUT
PoE IN

9
STEP 1 - CASE B
Connecting to a
Internet Router
1
2

10
Connect the Ethernet Controller to the
Connection Hub using port 1 (indicated as PoE IN)
Connect a free port ranging from 2 to 7 to your
Internet Router (doNOT connect to the port
indicated as PoE OUT)
Plug the Ethernet Controller to a power source
1
2
3
PoE IN

11
STEP 2
Enable the PoE
1

12
Verify the status of the PoE by looking for the
is already activated.
Enable the PoE by pressing and holding the button
will remain activated even if you disconnect the
Controller or the Wi-Fi Bridge/Internet Router
Wait for the Wi-Fi Bridge / Internet Router to connect.
This process can take up to 1 minute.
1
NOTE: Enable the PoE only on the controller connected to port 1 (PoE IN)

TYPICAL
Network layout
for multiple Connection Hubs
13

NOTE
The maximum number of Connection Hubs is delimited by the
number of available ethernet ports in your Internet Router.
14
PoE OUT
PoE IN

If you need any further information,
please feel free to contact us:
[email protected]