U-Line H-5779 User manual

0117 I H - 577 9PAGE 1 OF 3
H-5779
INFRARED HEATER
WALL MOUNT
1-800-295-5510
uline.com
π
ASSEMBLY
WARNING! EXPLOSION AND FIRE HAZARD!
Serious injury or death may occur.
• Do not use in locations containing hazardous
atmospheres.
• Do not use inside residences.
• Disconnect from electrical supply before
installing or servicing this heater.
HANGING THE WALL MOUNT
1. Attach the mounting bracket to a wall stud as shown
below using four wall mounting bolts. (See Figure 1)
NOTE: Use the back plate of the wall mounting
bracket as a template to pre-drill the holes for
mounting bolts.
CAUTION! The installer must be certain the wall
mounting bracket is attached to a minimum
of a 2 x 4" wall stud that is able to support 25
pounds continuously.
PARTS
50 mm Wall Mounting
Bolt x 4
10 mm Allen Bolt x 3 Nut x 3 Allen Wrench
Small Wrench Wall Mounting Bracket Heater Head Assembly
Wall Mounting
Bracket
2 x 4''
Stud
Wall Mounting
Bolts
Heating Bulb
Tilting Support Bracket
Wall Mounting
Bracket
Front Safety Guard
ASSEMBLY DIAGRAM
Figure 1

PAGE 2 OF 3 0117 I H - 577 9
ATTACHING HEATER TO WALL MOUNT
1. The heater support bracket is attached to the heater
head assembly.
2. Attach heater support bracket to wall mounting
bracket using three 10 mm Allen bolts and three
nuts. (See Figure 2)
NOTE: The mounting bracket is designed to
support the weight of the heater only. Do not
hang any object other than the heater from
the wall mounting bracket, swivel arms or
support bracket.
WARNING! Do not mount the heater on the
ceiling. Mount only as described previously to
a 2 x 4" wall stud.
HEATER INSTALLATION
Wall Mounting
Bracket
Heater Support Bracket
(Attached to Heater)
OPERATION
GROUNDING INSTRUCTIONS
This heater is for use on a properly grounded, 120 volt
outlet. The cord has a plug as show in Figure 3. An
adapter as shown at C is available for connecting
three-blade grounding-type plugs to two-slot
receptacles. The green grounding lug extending
from the adapter must be connected to a permanent
ground such as a properly grounded outlet. The
adapter should not be used if a three-slot grounded
receptacle is available. (See Figure 3)
OPERATING THE HEATER
1. Plug power cord into 120V AC power outlet.
2. Use pull cord to turn heater power on and off.
MAINTENANCE
WARNING! Always disconnect heater from
power supply before servicing.
WARNING! Risk of burns. This heater is hot while
operating. Allow to cool completely before
performing maintenance or storing.
WARNING! When servicing or replacement of a
component in the heater requires the removal
or disconnection of a safety device, that safety
device must be re-installed properly before
operating the heater.
CLEANING
1. Clean the outer shell of the heater with a soft cloth
and allow to dry completely before operating
heater.
2. Do not use abrasives, rough brushes or scrubbing
pads to clean the heater.
WARNING! Fire or explosion may occur. Do not
use alcohol, gasoline, furniture/metal polish or
any other flammable substance to clean this
heater.
NOTE: Use compressed air to clean any dirt or
debris from the front guard or around the bulb.
Figure 2
B
A
C
Grounding Means
Grounding Pin
Metal Screw
Grounding Methods
Cord
Figure 3

PAGE 3 OF 3 0117 I H - 577 9
TROUBLESHOOTING
OPERATING ISSUE CAUSES RECOMMENDATIONS
NO POWER 1. Unit is not plugged in properly.
2. Defective fuse.
1. Connect unit to power supply.
2. Replace fuse.
πCHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
STORAGE
SHORT TERM STORAGE
1. Disconnect heater from power supply.
NOTE: For heaters used outdoors, do not store
outdoors while not in use.
LONG TERM STORAGE
1. Disconnect heater from power supply.
2. Remove heater from wall mount.
NOTE: Leave wall mounting bracket hanging
during off-season for easy installation when
heater is taken out of storage.
3. Complete all cleaning procedures.
4. Wrap cord and heater in plastic shipping bags.
5. Store in a cool, dry place.
NOTE: Keep original shipping materials to store
heater during off-season.
MAINTENANCE CONTINUED