Ubiquiti AirCube ACB-AC User manual

24/10/2022, 12:04
ACB-AC Quick Start Guide
https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html
1/8
airCube AC Access Point Power Adapter
24V PoE In Port
Package Contents
Hardware Overview
ACB-AC Quick Start Guide

24/10/2022, 12:04
ACB-AC Quick Start Guide
https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html
2/8
Ports 2-3
WAN Port
Power Port
LED
Reset Button
This Gigabit Ethernet port is available to connect a 10/100/1000 Mbps device to
the internet. It also accepts 24V PoE input and can be used to power the
airCube.
These Gigabit Ethernet ports are available to connect 10/100/1000 Mbps
devices to the internet.
This Gigabit Ethernet port connects to and powers a 24V PoE airMAX device.
The Power Adapter connects to this port.
The LED lights up when the airCube is powered on.
Resets to factory defaults. The device should be running after bootup is
complete. Press and hold the Reset button for about 10 seconds until the LED
starts flashing and then becomes solidly lit. After a few seconds, the LED will
turn off, and the device will automatically reboot.
Hardware Installation
1.
ACB-AC Quick Start Guide

24/10/2022, 12:04
ACB-AC Quick Start Guide
https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html
3/8
2.
Web UI Configuration
To configure the airCube using a web interface:
1. Launch your web browser and go to: https://192.168.1.1
NOTE: The device used to configure the airCube must be on the same
network as the airCube itself.
2. Enter ubnt for the Username, and type in the QR code password for the
Password. Then click Login.
ACB-AC Quick Start Guide

24/10/2022, 12:04
ACB-AC Quick Start Guide
https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html
4/8
NOTE: The QR code password can be found on the bottom of the
airCube. It is labeled PSWD.
3. Follow the on-screen instructions.
Specifications
ACB-AC
Dimensions 87.80 x 89.50 x 89.25 mm
(3.46 x 3.52 x 3.51")
Weight 280 g (9.88 oz)
Management Interface Wi-Fi / Ethernet
Networking Interface (4) Gigabit Ethernet Ports
LED Status
Operating Frequency 2.4 GHz
5 GHz
Antenna Gain
2.4 GHz 4 dBi
5 GHz 5 dBi
Max. Speeds
2.4 GHz 300 Mbps
5 GHz 866.7 Mbps
Max. Power Consumption 8.5W
Max. TX Power 22 dBm
Power Supply 24VDC
Power Method 24VDC, 0.83A
PoE 24V In on Ethernet Port 1
PoE Out Controllable 24V PoE Out (4, 5+, 7, 8-) on WAN Port
Supported Voltage Range 22-26V
Operating Temperature -10 to 50° C
(-14 to 122° F)
Operating Humidity 5 to 95% Noncondensing
ESD/EMP Protection ± 24 kV Contact / Air
Certifications CE, FCC, IC
Safety Notices
1. Read, follow, and keep these instructions.
2. Heed all warnings.
3. Only use attachments/accessories specified by the manufacturer.
ACB-AC Quick Start Guide

24/10/2022, 12:04
ACB-AC Quick Start Guide
https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html
5/8
WARNING: Do not use this product in location that can be submerged by water.
WARNING: Avoid using this product during an electrical storm. There may be a
remote risk of electric shock from lightning.
Electrical Safety Information
1. Compliance is required with respect to voltage, frequency, and current requirements
indicated on the manufacturer’s label. Connection to a different power source than those
specified may result in improper operation, damage to the equipment or pose a fire hazard if
the limitations are not followed.
2. There are no operator serviceable parts inside this equipment. Service should be provided
only by a qualified service technician.
3. This equipment is provided with a detachable power cord which has an integral safety
ground wire intended for connection to a grounded safety outlet.
a. Do not substitute the power cord with one that is not the provided approved type. Never
use an adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the
grounding wire.
b. The equipment requires the use of the ground wire as a part of the safety certification,
modification or misuse can provide a shock hazard that can result in serious injury or
death.
c. Contact a qualified electrician or the manufacturer if there are questions about the
installation prior to connecting the equipment.
d. Protective earthing is provided by Listed AC adapter. Building installation shall provide
appropriate short-circuit backup protection.
e. Protective bonding must be installed in accordance with local national wiring rules and
regulations.
Limited Warranty
ui.com/support/warranty
The limited warranty requires the use of arbitration to resolve disputes on an individual basis,
and, where applicable, specify arbitration instead of jury trials or class actions.
Compliance
FCC
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions.
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
ACB-AC Quick Start Guide

24/10/2022, 12:04
ACB-AC Quick Start Guide
https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html
6/8
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
The device has been approved by the FCC under FCC ID: SWX-ACBAC.
ISED Canada
CAN ICES-3(B)/NMB-3(B)
This device complies with ISED Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
The device has been approved by ISED Canada under IC: 6545A-ACBAC.
The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems.
CAN ICES-3(B)/NMB-3(B)
Le présent appareil est conforme aux CNR d’ISDE Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. l’appareil ne doit pas produire de brouillage;
2. l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
L’appareil ont été approuvés par ISDE Canada en vertu IC: 6545A-ACBAC.
Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une
utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de
satellites mobiles utilisant les mêmes canaux.
IMPORTANT NOTE:
Radiation Exposure Statement:
This equipment complies with radiation exposure limits set forth for an uncontrolled
environment.
This equipment should be installed and operated with minimum distance 20 cm between the
radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
ACB-AC Quick Start Guide

24/10/2022, 12:04
ACB-AC Quick Start Guide
https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html
7/8
AVIS IMPORTANT :
Déclaration sur l’exposition aux rayonnements :
Cet équipement est conforme aux limites prévues pour l’exposition aux rayonnements dans
un environnement non contrôlé.
Lors de l’installation et de la mise en fonctionnement de l’équipement, assurez-vous qu’il y
ait une distance minimale de 20 cm entre l’élément rayonnant et vous.
Cet émetteur ne doit être installé à proximité d’aucune autre antenne ni d’aucun autre
émetteur, et ne doit être utilisé conjointement à aucun autre de ces appareils.
Australia and New Zealand
Brazil
Nota: Este equipamento não tem direito à proteção contra interferência prejudicial e
não pode causar interferência em sistemas devidamente autorizados.
CE Marking
CE marking on this product represents the product is in compliance with all directives that are
applicable to it.
Country List
AT BE BG CY CZ DE DK EE EL ES FI FR HR HU
IE IT LV LT LU MT NL PL PT RO SE SI SK UK
BFWA (Broadband Fixed Wireless Access) members noted in blue
Note: This device meets Max. TX power limit per ETSI regulations.
The following apply to products that operate in the 5 GHz frequency range:
Note: This device is restricted to indoor use only when operating in the 5150 - 5350
MHz frequency range within all member states.
Note: All countries listed may operate at 30 dBm. BFWA member states may operate
at 36 dBm.
Note: Operation in the 5.8 GHz frequency band is prohibited in BFWA member states.
Other countries listed may use the 5.8 GHz frequency band.
ACB-AC Quick Start Guide

24/10/2022, 12:04
ACB-AC Quick Start Guide
https://dl.ui.com/qsg/ACB-AC/ACB-AC_EN.html
8/8
WEEE Compliance Statement
Declaration of Conformity
Online Resources
© 2022 Ubiquiti Inc. All rights reserved.
ACB-AC Quick Start Guide