Ubiquiti LTU-Lite User manual

LTU-Lite Wall Mount Bracket Screws (Qty. 2)
Screw Anchors (Qty. 2) Zip Tie Gigabit PoE (24V, 0.5A) with
Mounting Bracket
Package Contents
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD

Power Cord
Installation Requirements
LTU PtMP AP, such as model LTU-Rocket
Phillips screwdriver for wall-mounting
Outdoor, shielded Category 6 (or above) cabling and shielded RJ45 connectors are
required for all wired Ethernet connections.
Surge protection should be used for all outdoor installations. We recommend that
you use two Ethernet Surge Protectors, model ETH-SP-G2, one near the device and
the other at the entry point to the building. The ETH-SP-G2 will absorb power surges
and safely discharge them into the ground.
Note: For guidelines about grounding and lightning protection, follow your
local electrical regulatory codes.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD

Hardware Overview
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD

System LED
Ethernet Port
Reset Button
Blue Initial power-up.
Flashing White Bootup in progress.
White Ready for use.
Alternating
Blue/White Firmware upgrade in progress.
This 10/100/1000 Ethernet port is used to connect the power and should be
connected to the LAN and DHCP server.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD

To reset to factory defaults, press and hold the Reset button for more than 10
seconds while the device is powered on.
Hardware Installation
1.
2.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD

3.
Wall Mount
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD

1.
2.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD

3.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD

4.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD

5.
Create PDF in your applications with the Pdfcrowd HTML to PDF API PDFCROWD