UCORE ELECTRONICS UCE-DSO212 User manual

UCE-DSO212 DIGITAL OSCILLOSCOPE
HOW TO UPDATE TUTORIAL
UCORE ELECTRONICS
www.ucore-electronics.com
2017

www.ucore-electronics.com
1
Contents
1. Introduction........................................................................................................................................ 2
2. Download the firmware..................................................................................................................... 2
3. Connection......................................................................................................................................... 2
4. Firmware Update............................................................................................................................... 4

www.ucore-electronics.com
2
1. Introduction
This document shows how to update the firmware of UCE-DSO212.
2. Download the firmware
Firstly, download the latest firmware as rar file, it includes DSO212.bin. Please visit our website for
the latest firmware.
3. Connection
Firmware file (dso212.bin) must be copied in UCE-DSO212 U Disc. There are two ways to
recognize the oscilloscope as an UCE-DSO212 U Disc to PC.
First way,
Plug the UCE-DSO212 with USB Cable to PC. And then Click ‘USB Disc’ icon at Settings menu
(Figure 1). USB Disc symbol is shown on the screen (Figure 2).
Figure 1.
Figure 2.

www.ucore-electronics.com
3
Figure 3.
When the device recognizes as U Disc, it is listed in the ‘Devices and drivers’ (Figure 3).
Second way,
Plug the UCE-DSO212 with USB Cable to PC. And then while pressing and holding ‘BOOT’ button,
press and release ‘RESET’ button (Figure 4). Finally, release ‘BOOT button too. When the device
recognizes as U Disc, there will be a connection information on the screen (Figure 5) and it is listed
in the ‘Devices and drivers’ (Figure 3).
Figure 4.
Figure 5.

www.ucore-electronics.com
4
4. Firmware Update
After recognizing as U Disc, firmware file (dso212.bin) must be copied in UCE-DSO212 U Disc
(Figure 6). And then reset the device. To reset the device, you can press ‘RESET’ button (Figure
4).
Figure 6.
After reset, the update progress will start and there will be some information about process on the
screen (Figure 7). At the end of the process, the firmware file is deleted.
Figure 7.
The firmware update causes to lose all stored data such as oscilloscope configuration, touch panel and ADC
calibration etc. So, at the first boot, oscilloscope ask you to calibrate the device.