Unfinished Furniture of Wilmington OT-70A User manual

ITEM NO.: OT-70A
REVISED SEP 0
9
, 2014
Printed in Vietnam
ASSEMBLY INSTRUCTIONS
Description
Item No.
:
HAMPTON
ACCENT TABLE W/SHELVES
: OT-70A

ITEM
NO.
:
OT
-
70
A
REVISED SEP 0
9
, 2014
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1 B Side frame
(L-R)
2
C Shelf 1 D Bottom
panel
1

ITEM NO.: OT-70A
REVISED SEP 0
9
, 2014
Printed in Vietnam
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Long bolt
(M6x35mm) 8 2
Flat washer
(6.5x16mm) 8
3
Lock washer
(6.5x11mm) 8 4
Shelf support
bracket 4
5
Allen key
(4X80mm) 1 6
Screw
(M3.5X15mm) 4
STEP 1
Attach side frame (B) to the top (A) with bolt (1), washer (2) and (3) as shown below. Tighten with
Allen key (5).

ITEM
NO.
:
OT
-
70
A
REVISED SEP 0
9
, 2014
Printed in Vietnam
- 4 -
STEP 2
Attach bottom panel (D) to the side frame (B) with bolt (1), washer (2) and (3) as shown below.
Tighten with Allen key (5).

ITEM
NO.
:
OT
-
70
A
REVISED SEP 0
9
, 2014
Printed in Vietnam
- 5 -
STEP 3
Attach brackets (4) to the unit as shown below.
STEP 4
Attach the Adjustable Shelf (C) to the unit with screws (6) as shown below. Tighten with a screwdriver.