Unfinished Furniture of Wilmington C-219 User manual

ITEM
NO.
:
C
-
219
REVISED JUL 2, 2012
Printed in Vietnam
- 1 -
Description
Item No.
:
COUNTRY FRENCH LADDERBACK
CHAIR W/WOOD SEAT
: C-219
ASSEMBLY
INSTRUCTIONS

ITEM
NO.
:
C
-
219
REVISED JUL 2, 2012
Printed in Vietnam
- 2 -
BEFORE ASSEMB
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Back 1 B Seat frame 1
C Wood seat 1 D Front leg
(L-R) 2
E
Side
stretcher
(L-R)
2 F Center
stretcher 1
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM
NO.
:
C
-
219
REVISED JUL 2, 2012
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1
Long bolt
(M6x80mm)
4
2
Short bolt
(M6x60mm)
4
3
Lock washer
(6.5x11mm)
11 4
Flat washer
(6.5x19mm)
11
5
Allen key
(4mm)
1
6
Screw
(M4x35mm)
10
7 Short bolt
(M6x40mm) 3
STEP 1
Attach Seat Frame (B) to the Back (A) with bolts (7) and (1), and Washers (3) and (4). Tighten with
Allen Key (5) as shown below.
Note: DO NOT fully tighten any of the bolts, until the chair is assembled, then put on a flat level
surface to make sure the chair is level and then tighten the bolts.

ITEM
NO.
:
C
-
219
REVISED JUL 2, 2012
Printed in Vietnam
- 4 -
STEP 2
Attach Middle stretcher (F) to Side Stretchers (E) with Screws (6). Tighten with a screwdriver.
STEP 3
Attach Front Legs (D) to the seat frame with bolts (2), and Washers (3) and (4). Tighten with Allen Key
(5).
Place Side Stretchers (E) (from step 2) between front and back legs, use the screwdriver to tighten
the screws (6) as shown below.

ITEM
NO.
:
C
-
219
REVISED JUL 2, 2012
Printed in Vietnam
- 5 -
STEP 4
Attach the Seat (C) to top of the seat frame (from Step 3) by using Screws (6) tighten with a screw
driver.