Unfinished Furniture of Wilmington HAMPTON OT-2013X User manual

ITEM NO.: OT-2013X
ISSUED NOV 22, 2017
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: HAMPTON NARROW END TABLE 26X22X26H
: OT-2013X

ITEM NO.: OT-2013X
ISSUED NOV 22, 2017
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws, bolts until all completely assembled.
-Keep all hardware parts out of reach of children.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: OT-2013X
ISSUED NOV 22, 2017
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Top & Shelf
2
B
Side frame
(L-R)
2
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Bolt
(M6 x 35mm)
8
2
Flat washer
(6.5 x 19mm)
8
3
Lock washer
(6.5 x 13mm)
8
4
Allen key
(M4 x 30mm x 110mm)
1

ITEM NO.: OT-2013X
ISSUED NOV 22, 2017
Printed in Vietnam
- 4 -
STEP 1
Attach top (A) to side frames (B) with bolts (1), and washers (3) and (2) as shown below. Tighten with
Allen key (4).
STEP 2
Attach shelf (A) to side frames (B) with bolts (1), and washers (3) and (2) as shown below. Tighten with
Allen key (4).