Unfinished Furniture of Wilmington MISSION SERVER SV-31 User manual

ITEM NO.: SV-31
REVISED NOV 29, 2014
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: MISSION SERVER
: SV-31

ITEM NO.: SV-31
REVISED NOV 29, 2014
Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior
to beginning assembly, however, make sure all parts and hardware are included and free of
obvious defect. If a part is missing or defective, please contact the store where purchased. If
hardware is missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid
the parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the
finish of your product. Protect the surface of the product with cloth if you are using any
product with rubber feet or base.
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before
continuing, please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top with
Drawers 1 C Side Frame 2
B Shelf 1
BEFORE ASSEMBLY
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: SV-31
REVISED NOV 29, 2014
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before
continuing, please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Bolt
(M6x30mm) 8 4 Knob
(ɸ30x20mm) 2
2 Flat washer
(6.5x13mm) 8
5 Pan head screw
(M4x30mm) 2
3 Spring washer
(6.5x11mm) 8
6 Allen key
(4x80mm) 1
STEP 1
Attach the side frame (C) to the shelf (B) and the top (A) with bolts (1), washers (2) and (3),as
shown below. Tighten with the Allen key (6).
1
6
3
2
C
C
B
A

ITEM NO.: SV-31
REVISED NOV 29, 2014
Printed in Vietnam
- 4 -
5
4
STEP 2
Attach the knobs (4) to front of drawers with screws (5), as shown below. Tighten with a screwdriver.