Unfinished Furniture of Wilmington OT-62S User manual

ITEM NO.: OT-62S
ISSUED JUN 17, 2019
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: PREVAIL FLIP OPEN SOFATABLE
: OT-62S

ITEM NO.: OT-62S
ISSUED JUN 17, 2019
Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
-Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish
of your table. Protect the surface of the table with cloth if you are using any product with
rubber feet or base.
BEFORE ASSEMBLY
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: OT-62S
ISSUED JUN 17, 2019
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Flip Top
1
B
Leg
(L-R)
4
C
Bottom shelf
1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Bolt
(M8 x 60mm)
8
4
Pan head screw
(M3.5 x 15mm)
8
2
Lock Washer
(8.5 x13mm)
8
5
L-bracket
4
3
Flat Washer
(8.5 x19mm)
8
6
Allen Key
(M4 x 30mm x 110mm)
1

ITEM NO.: OT-62S
ISSUED JUN 17, 2019
Printed in Vietnam
- 4 -
Insert shelf (C) into legs (B), and then attach legs (B) to the top (A) with bolts (1), and washers (2) and
(3) as shown below. Tighten with Allen key (6).
STEP 2
Attach shelf (C) to legs (B) with brackets (5) and screws (4) as shown below. Tighten with a screwdriver.
Pull out the wood supports to hold the table top in open position.
STEP 1

ITEM NO.: OT-62S
ISSUED JUN 17, 2019
Printed in Vietnam
- 5 -
STEP 3
Fold the two leaves and push wood supports toward the center of the table top, as shown below.