Unfinished Furniture of Wilmington T-3890X User manual

ITEM NO.: T-3890X
ISSUED FEB 23, 2016
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: SHAKER 38X72X90 W/SELF STORE LEAF
: T-3890X

ITEM NO.: T-3890X
ISSUED FEB 23, 2016
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the
finish of your table. Protect the surface of the table with cloth if you are using any product
with rubber feet or base.

ITEM NO.: T-3890X
ISSUED FEB 23, 2016
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Top
1
B
Leg
4
C
Extension
Leaf
1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Hexagon nut
(M8 x 13mm)
8
2
Lock washer
(8.5 x 13mm)
8
3
Flat washer
(2X8.5 X 19mm)
8
4
Wrench
(13mm)
1

ITEM NO.: T-3890X
ISSUED FEB 23, 2016
Printed in Vietnam
- 4 -
STEP 1
Attach legs (B) to the top (A) with washers (2) and (3), and nuts (1) as shown below. Tighten with the
wrench (4).
STEP 2
Unlock the table top from both sides underneath the top as shown below.
Pull the two parts of the table top apart.

ITEM NO.: T-3890X
ISSUED FEB 23, 2016
Printed in Vietnam
- 5 -
STEP 3
Place the leaf (C) in the center of the open table top. Push the table top closed. Lock the mechanism
underneath the table top as shown below.