Uninet iColor 500 User manual

Quick Start Guide
1. Remove the packing materials
and check the components.
* Please note the blue handle on the white cartridge is already in the locked position *
2. Remove the fuser lock.
for the iColor 500
4. Using the provided USB drive “UniNet iColor Software”, install the driver.
Only connect the Printer to the PC when prompted to by the software.
6. If purchased, install the iColor TransferRIP software and insert the
dongle into an available USB port. The software is located on the
“UniNet iColor Software” USB Drive.
When prompted, enter the Update Code.
Your code is in a text file on the “UniNet iColor Software” USB Drive.
Please copy and paste the entire string of code. The date below
will automatically populate. Then click “Close”.
www.icolorprint.com
3. Uninstall the cartridges to remove the protective orange film from each. Lock the blue lever forward. Reinstall the cartridges.
5. Connect the power cord and USB cable to the printer. Power on the printer.
3232 W. El Segundo Blvd, Hawthorne, California 90250 - [email protected] www.icolorprint.com

7. In Step 1 of the iColor TransferRIP software, import the two
profiles. The profiles are located on the “UniNet iColor Software”
USB Drive.
8. Then choose the desired profile based on the Black or White
cartridge being installed. Click on “Color Mapping”. Choose the
desired color mapping option. The location of the cartridges in
the printer
must match the
mapping in the
software. Then
click “Save”
and select the
desired profile.
Note: There are two options for “Color Mapping”
For Underprinting white.
Typically used for right side reading applications
like printing color on clear or dark medias
For Overprinting white.
Typically used for garment decoration.
For detailed instructions please refer to the iColor 600 Printer User Manual and the iColor TransferRIP User Manual
9. In Step 2 of the iColor TransferRIP software, select your paper
size then click “Load File”. Then click the preview graphic.
10. In Step 3 of the iColor TransferRIP
software, make any desired color
adjustments to the artwork.
Then click “Next”.
11. In Step 4 of the iColor TransferRIP software,
modify the white coverage depending on media
and artwork. 150% to 250% is suggested for most
applications. Then click “Next”.
12. In Step 5 of the iColor TransferRIP
software, adjust settings to print the artwork
based on the media being used. Use of the
MPT Tray is recommended. Then click “Print”.
When prompted, press the “online” button on
the front panel of the printer to print the job.
Note - Use of the “Underfilling” feature is highly recommended.
3232 W. El Segundo Blvd, Hawthorne, California 90250 - [email protected] www.icolorprint.com