Edition 21.4.21 | Product design and technical data may be subject to changeEdition 21.4.21 | Product design and technical data may be subject to change
Power
5 ~ 30 Watts
unios.com
Page 1/4
Eclipse G2 Glide 67
unios.com
Page 4/4
Base
Codes
LINEAR SERIES
Material
Aluminium
IP Rating
67
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
CAUTION – This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.
Glide 67 GI25
-GI25XX.XX
Glide 67 GI25T
-GI25TXX.XX
Glide 67 GI40
-GI40XX.XX
Glide 67 GI40T
-GI40TXX.XX
Install Person/s
1-2
45
28.6
45
40.9
24.9
44
24.7
20.9
45
40
80
Glide67 GI25 Glide67 GI25T Glide67 GI40 Glide67 GI40T
Mounting Guide
Vertical Installation
A B B
Note: A is the first measurement for both ends. Ensure not to allow product to bend excessively.
Product Code Max. single length run (X)
ECM0XX05 20m
10m
6m
5m
ECM0XX10
ECM0XX15
ECM0XX20
6.5mECM0XXFP.15XX.15XX
Wiring Options
B
C
A
A+B+C= X
Option 2
X
X
X
Option 1
For dimming capabilities, luminaire must be paired with
dimmable driver. Please refer to driver's instructions for
pairing of suitable systems.
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment).
Corrosion Protection
It is important to note that care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
Please also note that any chemical applications on
the luminaire or chemical contact via installation will
cause corrosion of the surface of the luminaire and will
void the warranty.
Ambient Conditions
Recommended to install in an
ambient temperature <35°C.
Length
1000mm
2000mm
3000mm
Hole Qty
3
5
6
A
150mm
200mm
250mm
B
350mm
400mm
500mm
Proper Handling
GI25, GI40
GI25T
1000mm
H
<20mm
1
2
