Unitech EA320 User manual

EA320 Gun Grip / Charging Cradle
How to use the gun grip
Step 1 : Push up /down the release buttons on the both
sides to unlock / lock the terminal on the gun grip.
Notice : Please remove the hand strap on EA320 before
using the gun grip.
Release button down
(lock position)
Release button up
(unlock position)
Quick Start Guide
V1.0
How to use the gun grip
Step 2 : Push up the release buttons to unlock position
and then slide the terminal into the gun grip.
Push down the release buttons to lock position.
How to use the charging cradle
￭ When the battery is charging :
Connect to the power : Logo light is on.
Battery Charging : Red light is on.
Battery Fully Charged :Green light is on.
Charging
Fully Charged

How to use the charging cradle
￭ When the terminal is charging :
Please check the LED status on terminal.
Terminal Charging : Red light is on.
Terminal Fully Charged :Green light is on.
CAUTION!  To ensure the unit working properly, please keep all connectors
away from the contaminants staying inside of them such as dust,
grease, mud, and water. The negligence may cause the unit with
no communication, short circuited, overheated and so on.
 If the connector is damaged, please ensure the connector is being
fully repaired before using the unit to avoid causing short circuited.
http://www.ute.com/
Copyright 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.