Unitech EA630 User manual

Quick Start Guide
- EA630 Quick Start Guide -
Package
Please make sure the following contents are in the EA630 gift box.
If something is missing or damaged, please contact
your unitech representative.
The package contents
EA630 Terminal
Battery
USB Type C Cable
Quick Start Guide
Regulatory Compliance Statements
Optional accessories
Terminal Power Adapter (with US or EU plug)
Hand Strap
Cradle + Cradle Power Adapter
1-slot Terminal & Battery Charging Cradle
1-slot Ethernet & Battery Cradle
1-slot USB & Battery Cradle
Glass Screen Protector
608509G V1.1
Product View
Product View

Installing the Battery and Battery Cover
Insert battery in the direction as shown in the picture below. Checking LED Status
LED Description
Red Light ￭Battery Charging
￭Twinkling to indicate battery
low status(less than 15%)
Green Light ￭Battery Fully charged
￭Barcode scan good read
Blue Light Message
If scanner app is running, LED control by scanner app.
No LED (Red and Green) display when battery is out(even AC IN)
1. Unlock the battery cover by turning the knobs
a quarter of a turn (90°). Lift the battery cover up
to 45 degrees (45°), then gently pull the cover off.
2. Pull the battery up to remove it.
3. Lock the battery cover by turning the knobs
a quarter of a turn (90°). Make sure the battery cover
is securely closed, or you may be unable to turn on
the terminal.
5
For other product documentation, please scan the QR code below for more information.
WARNING! There is a risk of fire and burns if the battery is handled improperly. DO NOT
disassemble, crush, puncture, short external contacts, or dispose the battery
pack in fire or water. DO NOT attempt to open or service the battery. Dispose of
used batteries according to local recycling guidelines in your area.
CAUTION!
 To ensure the unit working properly, please keep all connectors
away from the contaminants staying inside of them such as dust, grease,
mud, and water. The negligence may cause the unit with no communication,
short circuited, overheated and so on.
 If the connector is damaged, please ensure the connector is being fully
repaired before using the unit to avoid causing short circuited.
http://www.ute.com/
Copyright 2020 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Charging the battery
Before using the terminal for the first time, you need to charge it for
about 24 hours. For the regular use, you can charge the terminal for
4 hours to recharge the battery to full capacity. To charge the terminal,
please use the USB charging cable or the cradle.
Connect the type C USB cable to the USB port on EA630 and the other
end of the USB cable connect to AC power adapter into the electrical
outlet on the USB plug. The charging LED indicator on EA630 is turning
red when it is in charging state.