UNITED UCH-885 User manual

CONVECTOR HEATER
USER INSTRUCTIONS
Model: UCH-885
This product is only suitable for well insulated spaces or occasional use.
IMPORTANT Read these instructions fully before using the heater. Retain
these instructions for future reference.

ASSEMBLY OF THE HEATER
Before using the heater, the feet (supplied separately in the carton), must be
fitted to the unit. These are to be attached to the base of the heater using the
4 screws provided, taking care to ensure that they are located correctly in the
bottom ends of the heater side moldings
SAFETY INSTRUCTIONS (to be read before operating the heater)
-Do not use the heater unless the feet are correctly attached.
-Ensure the power supply of the socket into which the heater is plugged is in
accordance with the rating label on the heater and that the socket is earthed.
-Keep the mains lead away from the hot body of the heater.
-Do not use this heater in the immediate surroundings of a bath, a shower or
a swimming pool.
-Never place the heater where it may fall into a bathtub or other water
container.
-Do not use outdoors.
-Do not cover or obstruct any of the heat outlet grilles or the air intake
openings of the heater.
-Do not place the heater on carpets having a very deep pile.
-Always ensure that the heater is placed on a firm level surface. Ensure that
the heater is not positioned close to curtains or furniture as this could create
a fire hazard.
-Do not position the heater in front of, or immediately below, a wall socket.
-Do not insert any object through the heat outlet or air intake grilles of the
heater.
-Do not use the heater in areas where flammable liquids are stored or where
flammable fumes may be present.
-The appliance is not intended for use by young children or infirm persons
without supervision.
-Young children should be supervised to ensure that they do not play with
the appliance.
-Always unplug the heater when moving it from one location to another.
-Do not use the heater if the power cord is damaged. If the power cord is
damaged it must be replaced by a recognized service agent or other qualified
person.

-The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning the use of the appliance by a person responsible for their safety.
-Do not cover. If covered, there is a risk of overheating or even fire.
-In order to avoid a hazard, due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching
device, such as a timer, or be connected to a circuit that is regularly switched
on and off by the utility.
-Children of less than 3 years should be kept away unless they are being
continuously supervised.
-Children aged from 3 years and less than 8 years shall only switch on/off
the appliance provided that it has been placed or installed in its intended
normal operating position and they have been given supervision or
instruction concerning the use of the appliance in a safe way, and that they
understand the hazards involved. Children aged from 3 years and less than 8
years shall not plug in, regulate and clean the appliance or perform user
maintenance.
-CAUTION- Some parts of this product can become very hot and cause
burns. Particular attention has to be given where children and vulnerable
people are present.
OPERATION OF THE HEATER
NOTE:- It is normal when the appliance is turned on for the first time or
when it is turned on after having not been used for a long period of time, for
it to emit some smell and fumes. This will disappear when the heater has
been on for a short while.
Choose a suitable location for the heater, taking into account the safety
instructions above.
Insert the plug of the heater into a suitable
socket.
Turn the THERMOSTAT fully in a clockwise
direction to the maximum setting.
Turn on the heating elements by means of the
HEATER SWITCHES on the side panel. You
may obtain three heating settings
(750/1250/2000W) by turning the heater
switch knob in a clockwise direction.

When the desired room temperature has been reached, the thermostat should
be turned slowly anti-clockwise until the thermostat is heard to click off and
the indicator light on the side panel is seen to go out. After this the heater
will keep the air temperature in the room at the set level by switching on and
off automatically.
PROTECTION AGAINST OVERHEATING
− An additional fitted safety thermostat protects the heater against
overheating and switches it off automatically. The service lamp then
goes out.
− If the device switches itself off, disconnect the mains plug from the
socket. The heater is ready for service again after a short cooling-off
phase (approx.15 minutes). Plug the mains plug back into the socket.
− If this repeats itself, first check whether the thermostat switch is set
correctly or if any objects hinder the heating operation.
CLEANING THE HEATER
Always unplug the heater from the wall socket and allow it to cool down
before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a
dry cloth. Do not use any detergents or abrasives and do not allow any
water to enter the heater.
STORING THE HEATER
When the heater is not used for long periods of time, it should be protected
from dust and stored in a clean dry place.
Note: this appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.

Model identifier(s):
UHC-885
Item
Symbol
Value
Unit
Item
Unit
Heat output
Type of heat input, for electric storage local space
heaters only (select one)
Nominal heat output
Pnom
1,9
kW
manual heat charge control, with
integrated thermostat
[no]
Minimum heat
Pmin
0
kW
manual heat charge control with
room and/or outdoor temperature
feedback
[no]
output (indicative)
Maximum continuous
heat output
Pmax,c
1,9
kW
electronic heat charge control with
room and/or outdoor temperature
feedback
[no]
Auxiliary electricity
consumption
fan assisted heat output
[no]
At nominal heat
output
elmax
0
kW
Type of heat output/room temperature control (select
one)
At minimum heat
output
elmin
0
kW
single stage heat output and no
room temperature control
[no]
In standby mode
elSB
0
kW
Two or more manual stages, no
room temperature control
[no]
with mechanic thermostat room
temperature control
[yes]
with electronic room temperature
control
[no]
electronic room temperature control
plus day timer
[no]
electronic room temperature control
plus week timer
[no]
Other control options (multiple selections possible)
room temperature control, with
presence detection
[no]
room temperature control, with
open window detection
[no]
with distance control option
[no]
with adaptive start control
[no]
with working time limitation
[no]
with black bulb sensor
[no]
Contact details
Kalliopi Karyda & Co LP
87A, 17th Noemvriou str, P.C. 55535
Thessaloniki –Greece
T: [phone] | F: [phone]

NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high
quality materials and components which can be recycled
and reused. This symbol means that electrical and
electronic equipment, at their end-of-life, should be
disposed of separately from your household waste. Please
dispose of this equipment at your local community waste
collection/ recycling centre.
In the European Union there are separate collection systems for used
electrical and electronicproducts.
Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Kalliopi Karyda & Co LP states that this product, complies with
the requirements of below directives:
EMC Directive 14/30/EU
Low Voltage Directive 14/35/EU
ErP Directive 09/125/EC
RoHS2 Directive 11/65/EU & 15/863/EU
CE-marking Directive 93/68/EEC
The detailed declaration of conformity can be found at
www.united-electronics.gr
Exclusive importer in Greece:
Kalliopi Karyda & Co LP
87A, 17th Noemvriou str, P.C. 55535
Thessaloniki – Greece
T: [phone] | F: [phone]
www.united-electronics.gr