UNITED UHR-835 User manual

Oil-Filled Radiator
INSTRUCTION MANUAL
Model UHR-835
DO NOT TURN HEATER UPSIDE-DOWN DURING OPERATION.

ASSEMBLY
Remove the heater and all the accessories from the carton.
1. Turn the heater upside down.
2. Position the wheel base assemblies between the end fins.
3. Attach them to the heater using the U-bolts and wing nuts supplied.
4. Tighten the wing nuts.
5. Turn the heater the right way up.
PARTS DESCRIPTION
1. Power switch
2. Thermostat knob
3. Handle
4. Oil filled fins
5. Castors
6. Cord storage
7. Fan heater
8. Power supply plug
OPERATING YOUR OIL-FILLED RADIATOR
Place the heater on the floor at least 90 cm away from the wall and any
other objects such as furniture, curtains or plants.
(Make sure the power supply used corresponds to the one on the rating
label)
With the thermostat control switch and the power setting switches in the
'0' position, plug the heater into the main power supply.
1. Room temperature can be adjusted using the thermostat simply. Turn the
thermostat knob clockwise, to increase the heat, and anti-clockwise to
decrease the temperature, until you reach the desired temperature.
2. Switch the heater to one of the following power settings.

a) Push switch one( I ) 1000W
b) Push switch two ( II ) 1500W
c) Push switches one _ two heat settings together.
c)Add separately the air blower: 400W
3. The power switch lights up when activated.
4. Turning the thermostat control clockwise will increase the "set" temperature.
5. Turning the thermostat anti-clockwise will decrease the "set" temperature.
6. Do not cover the heater at any time during operation. There is a risk of fire if
the heater is covered.
7. Once you have finished using your heater, turn the power switches, and the
thermostat control switch to the "0" positions, and unplug from the mains
supply.
Fan Operation
The fan can be switched on by means of the push button on the fan
unit within the control panel. The fan is switched on when the push
button is in the inward position and off when the button is in the
outward position.
CLEANING YOUR OIL-FILLED RADIATOR
1. Always disconnect the heater from the mains supply before cleaning.
2. Clean the outside of the heater by wiping with a damp cloth and buff
with a dry cloth.
3. Do not use waxes or polishes as these may react with the heater and
cause discoloration.
STORING YOUR OIL-FILLED RADIATOR
1. Save the box for off season storage.
2. Clean the heater following the cleaning instructions above.
3. Remove the wheel base assemblies.
4. Place the heater, and wheel assemblies in the original box, and store
in a cool and dry place.
5. If you choose to store your heater fully assembled be sure to cover it
to protect it from dust.
IMPORTANT SAFEGUARDS
1. Read the instructions carefully before use and save them for future
reference.
2. Always disconnect the heater from the main supply when not in use
and when cleaning.
3. Do not leave the heater "ON" unattended.

4. Never cover the heater as this may lead to risk of fire.
5. Keep the heater a distance of at least 90 cm from any combustible
material, such as furniture, curtains, bedding cloths or papers.
6. Keep the heater clean. Do not allow objects to enter the ventilation, as
this may cause electric shock, fire or damage the heater.
7. Close supervision is required when any appliance is used near or by
children.
8. Never allow the cord to touch wet or hot surfaces, become twisted or
be within the reach of children.
9. Do not use outdoors.
10. Do not place on or near a hot gas or electric burner.
11. Never use the appliance with a damaged cord or plug or after the
appliance has malfunctioned or been damaged in any way.
12. Never attempt to open any part or dismantle the controls.
Responsibility for failure cannot be accepted if these instructions
have been ignored.
13. Do not use the appliance for anything other than its intended use.
14. This appliance is intended for household use only.
15. Regulations concerning the disposal of the oil when scraping the
appliance have to be followed.
16. Any repairs that need to be done to the heater must be referred to an
authorized service agent only.
17. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent in order to avoid a hazard.
18. The heater must not be located immediately below a socket-outlet.
19. Do not use this heater in the immediate surroundings of a bath, a
shower or a swimming pool.
20. This heater is filled with a precise quantity of special oil. Repairs
requiring opening of the oil container are only to be made by the
manufacturer of his service agent who should be contacted if there is
an oil leakage. Regulations concerning the disposal of the oil when
scrapping the appliance have to be followed.
21.The appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety
22.Children should be supervised to ensure that they do not play with
the appliance.

NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality
materials and components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at
their end-of-life, should be disposed of separately from your
household waste.
Please dispose of this equipment at your local community waste
collection/recycling centre. In the European Union there are separate
collection systems for used electrical and electronic products.
Please help us to conserve the environment we live in!
DECLARATION OFCONFORMITY
This product is in compliance with the standards of the below regulations:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14 / 35 / EU
RoHS2 Directive: 11 / 65 / EU
The above listed regulations declare that this product is in compliance with
the following norms::
EN 55014-1:06+A1:09+A2:11
EN 55014-2:15
EN 61000-3-2:14
EN 61000-3-3:13
EN 60335-2-30:09+A11:12
EN 60335-1:12+A11
EN 62233:08
IEC 62321:08, IEC 62321-3-1:13, IEC 62321-4:13, IEC 62321-5:13, IEC 62321-6:15, IEC
62321-7-1:15
EXCLUSIVE IMPORTER IN GREECE:
Amiridis – Savidis S.A.
87A, 17th November Str - P.C. 55534
Pylaia - Thessaloniki - Greece
T: 2310944944 | F: 2310944940
www.amiridis-savvidis.gr
www.united-electronics.gr