UNITED UHM-876 User manual

USER’S MANUAL
for
MICA HEATERS
UHM-876 / UHM-877
This product is only suitable for well insulated spaces or occasional use.
Please read this instruction manual carefully before operation!
Keep in a safe place for future reference.

Ⅰ. Product Appearance
Ⅱ. Main Technical Date
Model
Rated Voltage
Rated Frequency
Rated Power
UHM-876
220-240V
50Hz
2000W
UHM-877
220-240V
50Hz
2000W
Ⅲ.Precaution Items For Safe Use
•Please read the product manual carefully before using the heater.
•Insert the plug into the socket (requirements for socket and power cord:
AC 220-240V, 50/60Hz,≥10A). The heater must not be located below a
fixed socket.
•Please operate according to the instructions of the manual. Any
unrecompensed operation can cause fire, short circuit and personal
injuries.
•Unauthorized extension of power cord is not allowed to avoid fire caused
by overheating of the extension part.
•In order to prevent short circuit, fire or damages to the appliance, never

insert any article into the heater or block the cooling net.
•Since the heater can generate heat, don not touch the hot surface with
uncovered human body to prevent burns. Grab the plastic handle at the
rear to move the heater when necessary. In case that children, animals
or lame people and people lacking self-discipline are on the spot and left
unattended, avoid using the appliance.
•Never use the heater outdoors.
•Do not use this heater in the immediate surroundings of a bath, a
shower or a swimming pool
•Do not use the appliance in area where gasoline, paint and flammable
liquid are used to stored.
•Never cover anything on the heater during use.
•To avoid current overload, do not share the use of a single socket with
other appliances.
•The heater must not be located below a fixed socket.
•If the power cord is damaged, it must be replaced by the manufacturer
or its maintenance agent or a similarly qualified person in order to avoid
potential hazards.
•Never use the product with automatic power-on programmer, timer or
other types of installations.
•In case of product failure, please contact after-sales service agent for
inspection and repairing. Unauthorized disassembling and replacement
of parts are not allowed.
•The product shall be packed properly to prevent it from dust and kept in
a well-ventilated, dry place.CAUTION:
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance
provided that it has been placed or installed in its intended normal operating position
and they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children aged from 3 years and less than
8 years shall not plug in, regulate and clean the appliance or perform user maintenance.

Ⅳ. How to install
Firstly, take the heater out the package and place it upside down on soft surface.
Secondly, take four screws from the accessories (two screw for each castor,
parallel the bevel of castor bracket to the bevel of the heater, if installed reversely,
the screw cannot be revolved in.) and aim them at the taps to tighten them.
Thirdly, Then just upright the heater and put it into use. You may refer to the
following figure.
OPERATION
1) Room temperature can be adjusted using the thermostat. Simply turn the
thermostat knob clockwise, to increase the heater, and anti-clockwise to
decrease the temperature, until you reach the desired temperature.
2) Switch the heater to one of the following power settings.
Push switch one (I) for 1000W
Push switch two (II) for 2000W
3) The power switch lights up when activated.
4) Turning the thermostat control clockwise will increase the “set” temperature.
5) Turning the thermostat anti-clockwise will decrease the “set” temperature.
6) Do not cover the heater at any time during operation. There is a risk of fire if
the heater is covered.
7) Once you have finished using your heater, turn the power switches off, and the
thermostat control switch to the “Low” positions, and unplug from the mains
supply.

Ⅵ.Circuit diagram

Information requirements for electric local space heaters

NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality materials
and components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their
end-of-life, should be disposed of separately from your household waste.
Please dispose of this equipment at your local community waste collection/recycling
centre. In the European Union there are separate collection systems for used
electrical and electronic products.
Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Kalliopi Karyda & Co LP states that this product, complies with the
requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14/ 35 / EU
ErP Directive 09 / 125 / EC
CE Marking: 93 / 68 / EEC & 15 / 863 / EU
RoHS Directive: 11 / 65 / EU
The detailed declaration of conformity can be found at www.united-electronics.gr
EXCLUSIVE IMPORTER IN GREECE:
Kalliopi Karyda & Co LP
87A, 17is Noemvriou str, P.C. 55535
Thessaloniki –Greece
T: [phone] | F: [phone]
www.amiridis-savvidis.gr
www.united-electronics.gr