URBAN OUTFITTERS Sanna Queen Bed User manual

Assembly Instructions
Page 1 of 3
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted.
Sanna Queen Bed
TOOLS REQUIRED BUT NOT INCLUDED:
(A) BOLT
M8 x 35mm 12x
PARTS INCLUDED
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight. Do not place over heat or Air conditioning vents.
Blot spills do not rub, with a clean white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden area.
You may need to re-tighten all bolts after initial use.
Do not throw away packing materials and carton until after assembly.
Assemble all parts on a clean smooth surface
(B) Flat Washer
M8 x 18mm 12x
(C) Spring Washer
M8x10mm 12x
(E) Headboard lx
1x
(F) Side rail
2x
(G) Footboard
1x
(H) Center rail
1x
(I) Roll Slats
1x
(D) Hex Key
1x
(J) Middle Legs
3x
(K) screw
51x

F
H
J
F
G
E
Step 1:
With help align the Side Rails (F) with the Headboard (E).
Hang and align the iron corner bracket on the bolts as
shown. Tighten with Wrench (D). Align the Footboard
(G) with the Side Rail (F). Hang and align the iron corner
bracket on the bolts as shown. Tighten with Wrench (D).
Step 2:
Align Center Rail (H) with the Headboard and
Footboard brackets as shown below. Press firmly into
place. Screw in Middle Legs (J) into the Center Rail as
shown. Adjust the Levelers until they touch the floor.
Assembly Instructions
Page 2 of 3
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted.
Sanna Queen Bed

Step 3:
1.Make sure your bed is fully assembled and bolts are tight.
2.With help unroll the slats onto a clean smooth surface.
3.With help carefully lay the roll slats into the bed frame.
4.Locate the "Slat Blocks＂mounted on the side rails.
5.The last slat roll will lock the Slat blocks as shown below.
Step 4:
Screw in each rail with Screws (K).You may need to re-tighten all bolts after use.
Assembly Instructions
Page 3 of 3
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted.
Sanna Queen Bed
I
SLAT LOCK
LAST SLAT