URBAN OUTFITTERS Hugo User manual

Hugo Shelf
Assembly Instructions
Page 1
Rev 1 04.22.22
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights. Any unauthorized
reproduction, adaptation, distribution or other infringement will be
B) Anchor x2C) Screw
[M4x35mm] x2
A ) Shelf x1
STEP 1
TOOLS REQUIRED BUT NOT INCLUDED:
Pencil, Level, Phillips head screw driver, Stud finder
WARNINGS:
Do not throw away packing materials and carton until after assembly.
Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight.
Do not place over heat or Air conditioning vents.
Blot spills do not rub, with a clean white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden area.
You may need to re-tighten all bolts after initial use.
PARTS INCLUDED
Place the shelf (A) against the wall in the desired position and check for level. Mark the position
through the holes in the back of the shelf (A) and remove the shelf (A) from the wall.

Hugo Shelf
Assembly Instructions
Page 2
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights. Any unauthorized
reproduction, adaptation, distribution or other infringement will be
STEP 2
If attaching to drywall, screw anchors (C) into the wall at the marked locations using a Phillips head screw driver.
Insert screws (B) into the anchors and partially tighten using a Phillips head screw driver. Leave enough space
between the wall and the screws (B) to accommodate the shelf (A). Hang the shelf (A) on the screws as shown
and tighten fully, do not over-tighten. If attaching to studs, you do not need to use the anchors (C).
For stud mounting: For non-stud mounting:
AB
Rev 1 04.22.22