URBAN OUTFITTERS EBBA CONSOLE User manual

EBBA CONSOLE
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted.
Page 1 of 3
TOOLS REQUIRED BUT NOT INCLUDED:
Phillips head screwdriver, hammer
WARNINGS:
Do not throw away packing materials and carton until after
assembly. Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight. Do not place overheat or air
conditioning vents. Adjust levelers so that the furniture sits flat on
uneven floors.
Blot spills do not rub, with a clean white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden area.
You may need to re-tighten all bolts after initial use.
PARTS INCLUDED
(A) Nylon glide
x 4
(B) Nylon strip
x1
(C) Bracket
x2
(D) Screw
[M3 x 32mm] x2
(E) Screw
[M3 x 19mm] x2

EBBA CONSOLE
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted.
Page 2 of 3
STEP 1
Lay the Console out onto a clean smooth surface such as carpet or cardboard. Use a hammer to tap the nylon glides
(A) into the base of the bookshelf as shown. Determine the desired orientation of the console rior to attaching the
nylon glides (A).

EBBA CONSOLE
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted.
Page 3 of 3
STEP 2
a) Align the Anti Tip Brackets (E) to the Top back of the Case. Insert Screws (F) and tighten completely. Do not over-tighten.
b) Contact your local hardware store to purchase the correct anchors for your wall-type.
c) Align the bracket to the wall and make sure they line up with the brackets on the back of the case from step (a).
d) Screw the bracket to the wall using the correct anchors.
e) Slide the case to the wall leaving a little bit of room between the case and the wall.
f) Feed the Nylon Strap through both brackets as shown and pull tight.
NOTE:
Anti-tip hardware
should be installed in
either console
orientation to prevent
tipping hazard