4
lightning.
16. Do not use the telephone to report a gas leak in the vicinity
of the leak. Under certain circumstances, a spark may
be created when the adapter is plugged into the power
outlet, or when the handset is replaced in its cradle. This
is a common event associated with the closing of any
electrical circuit. The user should not plug the phone into
a power outlet, and should not put a charged handset
into the cradle, if the phone is located in an environment
containing concentrations of ammable or ame-supporting
gases, unless there is adequate ventilation. A spark in
such an environment could create a re or explosion. Such
environments might include: medical use of oxygen without
adequate ventilation; industrial gases (cleaning solvents;
gasoline vapors; etc.); a leak of natural gas; etc.
17. Only put the handset of your telephone next to your ear
when it is in normal talk mode.
18. The power adapters are intended to be correctly oriented
in a vertical or oor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
19. Use only the power cord indicated in this manual.
20. For pluggable equipment, the socket-outlet shall be installed
near the equipment and shall be easily accessible.
21. In wall mounting position, make sure to mount the telephone
base on the wall by aligning the eyelets with the mounting
studs of the wall plate. Then slide the telephone base down
on both mounting studs until it locks into place. Refer to the
full installation instructions in the User Guide.
22. CAUTION: Keep small metallic objects such as pins and
staples away from the handset receiver.
23. WARNING: The product included (ITE) in this manual is to
be connected only to PoE networks without routing to the
outside plant.
SAVE THESE INSTRUCTIONS
