V-tech Let's Go Rescue Pup User manual

Instruction Manual
Let’s Go Rescue Pup

2
2
2
INTRODUCTION
Thank you for purchasing the Let’s Go Rescue Pup™.
I’m adopted and I’m a good puppy! I will be very happy when you feed
me, give me water, pat my head and take me for a walk. Learn about
colors and numbers with me and hear me sing!
Toy Bone
Battery Cover
Water Bottle
Hip Pouch
Fabric Belt
Food
Bowl
Leash Recognition
Volume Switch Adoption Card
Touch Sensor
On/Off/Mode
Selector
Color
Buttons
Mouth
Button
Leash Piece A Leash Piece B

3
3
3
INCLUDED IN THE PACKAGE
• Let’s Go Rescue Pup™
• 1 Hip Pouch
• 1 Fabric Belt
• 1 Adoption Card
• Quick Start Guide
• Leash Piece A
• Leash Piece B
• 1 Toy Bone
• 1 Food Bowl
• 1 Water Bottle
• 1 Sticker Sheet

4
4
4
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’instructions car il comporte
des informations importantes.
ASSEMBLY INSTRUCTIONS
With the Let’s Go Rescue PupTM, safety comes first. Adult assembly
required. For your child’s safety, do not let them play with this toy until
it is fully assembled.
Leash Assembly
1. Insert the end of Leash Piece A into the top of Leash Piece B.
2. Insert the end of Leash Piece B into the Leash Recognition on
the collar.
3. Hold the Leash and push the puppy along to play.

5
5
5
Hip Pouch and Belt Assembly
1. Identify the inner portion of the Fabric Belt by locating the long
section of the hook-and-loop closure.
2. With the inner portion of the belt facing the back of the Hip Pouch
where the two slots are, place the Fabric Belt ends through the
Hip Pouch slots from the inside of the pouch.
3. The seams will hold the Fabric Belt in place from the inside of the
Hip Pouch.
4. Put the Fabric Belt around the child’s waist and secure with the
hook-and-loop closure.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver
to loosen the screw and then open
the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
Hip Pouch and Belt Assembly
1. Identify the inner portion of the Fabric Belt by locating the long
section of the hook-and-loop closure.
2. With the inner portion of the belt facing the back of the Hip Pouch
where the two slots are, place the Fabric Belt ends through the
Hip Pouch slots from the inside of the pouch.
3. The seams will hold the Fabric Belt in place from the inside of the
Hip Pouch.
4. Put the Fabric Belt around the child’s waist and secure with the
hook-and-loop closure.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver
to loosen the screw and then open
the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.

6
6
6
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended are
to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.

7
7
7
RECHARGEABLE BATTERIES
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
PERSONALIZE YOUR PUPPY
Congratulations on your puppy adoption! Stickers are provided to style
your puppy any way you want. Please securely stick the labels to any
smooth surface on the toy.
Fill out the included Adoption Card and keep it in a safe place. Write
your puppy’s name on the included bone-shaped sticker and stick it on
the puppy’s collar. Two dog tag stickers are provided.
Model: 80-552500-000-001
P/N: 92-012369-000-100
Size: 125 mm x 100 mm
Colour: 4C
Material: 80g Paper + UV+ Glue
客户贴Label
一张Label一份，
按实际尺寸裁切，
不能拼板。
This is to certify that
(your name)
I promise to love and care
for my new pet.
Date
Signature
and has welcomed it to its forever home!
has officially adopted (puppy’s name)
D
A
O
P
T
I
O
N
o
f
E
R
T
I
F
I
C
A
T
E
C
A
D
O
P
T
I
O
N
o
f
C
E
R
T
I
F
I
C
A
T
E
95-001088-000-000
This is to certify that
(your name)
I promise to love and care
for my new pet.
Date
Signature
and has welcomed it to its forever home!
has officially adopted (puppy’s name)
D
A
O
P
T
I
O
N
o
f
E
R
T
I
F
I
C
A
T
E
C
A
D
O
P
T
I
O
N
o
f
C
E
R
T
I
F
I
C
A
T
E
95-001088-000-000

8
8
8
ACTIVATE NORMAL PLAY MODE
This product is in Try-Me mode in the packaging. When you play with
the Let’s Go Rescue Pup™ for the first time, slide the On/Off/Mode
Selector to Learning mode or Role-Play mode, and insert the Leash
into the collar.You will hear three beeps to confirm that you have exited
Try-Me mode.
PRODUCT FEATURES
1. On/Off/Mode Selector
To turn the unit On, slide the selector
from Off to Learning mode or
Role-Play mode. To turn the unit Off,
slide the Selector to the Off position.
2. Volume Switch
To adjust the volume, slide the switch
between the Low or High volume
position.

9
9
9
3. Touch Sensor
Pat the puppy’s head to hear fun
responses and play games.
4. Push-Along Play
Push the puppy along for a walk to
hear cute responses, melodies or
sing-along songs. When the puppy
is pushed faster, the melodies play
faster. The puppy loves to walk with
the Leash. Attach the Leash to his
collar and go!
5. Color Buttons
Let’s learn colors and numbers with
the puppy. Press the Color Buttons to
learn about the colors yellow, red and
green, and the numbers 1, 2 and 3.
6. Water Bottle
Insert the Water Bottle into the
puppy’s Mouth when he is thirsty. He
feels better now!

10
10
10
7. Automatic Shut-Off
To preserve battery life, Let’s Go Rescue Pup™ will shut off
automatically after several minutes without input. The unit can
be turned on again by sliding the On/Off/Mode Selector, or by
pressing any of the Color Buttons.
NOTE: The Red Button will flash several times and power down
when the unit’s battery level is low. If the unit powers down or if the
light fades out during play, please install a new set of batteries.
ACTIVITIES
1. Learning Mode
Press the Color Buttons to learn about colors, numbers, and the
puppy’s accessories. Pat the puppy’s head for cute responses. Push
the puppy along to hear sounds, melodies and songs.
2. Role-Play Mode
Interact with the puppy in ten different role-play scenarios. He will
ask you to take him for a walk, pat his head, give him water and
more.The puppy also likes color and number games. Play with the
puppy to keep him healthy and happy.
SONG LYRICS
Song 1
For I’m a jolly good doggo,
For I’m a jolly good doggo,
For I’m a jolly good doggo,
Which nobody can deny.
Which nobody can deny.

11
11
11
Song 2
I am a happy dog, a friendly dog,
A dog who loves to walk.
Walk and talk and walk and sniff.
Love to sniff each and every whiff!
Song 3
Let’s go for a W-A-L-K, that’s walk, walk, walk.
If I got my leash on and my best pal,
Let’s go for a walky, walky, walk, walk, walk.
Song 4
Walking slowly, walking slowly,
Gives you time, gives you time.
To stop and smell the flowers,
Feel the sun or showers,
Sniff a lot, sniff a lot.
Song 5
Walking quickly, walking quickly,
Saves you time, saves you time.
Gets you where you’re going,
Feel the wind a blowing,
Through your hair, through your hair.
Walking quickly, walking quickly,
Saves you time, saves you time.
Gets you where you’re going,
Feel the wind a blowing,
Through your hair, through your hair!

12
12
12
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
5. Do not manually force the puppy’s head and legs to move.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.

13
13
13
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S. or 1-877-352-8697 in
Canada, or by going to our website at vtechkids.com and filling
out our Contact Us form located under the Customer Support
link. Creating and developing VTech®products is accompanied by
a responsibility that we take very seriously. We make every effort
to ensure the accuracy of the information, which forms the value of
our products. However, errors sometimes can occur. It is important
for you to know that we stand behind our products and encourage
you to contact us with any problems and/or suggestions that you
might have. A service representative will be happy to help you.

14
14
14
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
CAN ICES-003(B)/NMB-003(B)
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name:
Model:
Product Name:
Responsible Party:
Address:
Website:
VTech®
5525
Let’s Go Rescue Pup™
VTech Electronics North America, L.L.C.
1156 W. Shure Drive, Suite 200
Arlington Heights, IL 60004
vtechkids.com

TM & © 2022 VTech Holdings Limited.
All rights reserved.
IM-552500-000
Version:0
Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty