V-tech Marble Rush Launchpad Set User manual

Marble Rush™ Launchpad Set™
Instruction Manual
91-003989-000 US

2
INTRODUCTION
Thank you for purchasing the Marble Rush™ Launchpad Set™!
Get ready for a rush of non-stop action! Build thrilling courses, send the
marbles into motion and compete with family and friends through exciting
challenges complete with sounds and lights.
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE
Please keep save this manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de conserver ce guide car il comporte des informations
importantes.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of the unit, use a coin or screwdriver
to loosen the screw and then open the
battery cover.
3. Remove old batteries by pulling up on one
end of each battery.

3
4. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the
battery box. (For best performance, alkaline batteries or fully charged
Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WWARNING:
CHOKING HAZARD -Toy contains small parts and small balls.
Not for children under 3yrs.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to
be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

4
12
6
7
8
11
12
13
14
15
16
17
10
9
3
4
5
LABEL APPLICATION
Please securely stick the labels to the playset as indicated below:

5
1
6
2
78 8
4 5
10
13
3
11
14 15 16
9
1712
PRODUCT FEATURES
1. Rocket Sensor
When the Rocket Sensor detects a ball, the unit will
play sound effects.
2. Rocket Button
Press the button on the rocket to select the background
music.
B-02
M-02
T-04
B-04
T-03
M-01
M-05
M-06
T-01
M-07
M-11
T-02
M-04
M-14

6
3. Music/SFX Selector
Slide the selector all the way to the right to turn on both music and SFX. The
middle position plays SFX only with no background music. Slide the selector
all the way to the left to turn off both SFX and background music.
4. On/Off Switch
Slide the switch to the Off position or the On
position to turn the unit Off or On.
5. Automatic Shut-Off
To preserve battery life, the Marble Rush™ Launchpad Set™ will
automatically power-down after several minutes without input. The unit
can be turned on again by sliding the On/Off Switch to the on position or
by sliding the Music/SFX Selector to a different position.The unit will also
automatically turn off when the batteries are very low.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be used for an extended period
of time.
4. Do not drop the unit on hard surfaces or expose the unit to moisture or
water.

7
TROUBLESHOOTING
If for some reason the unit stops working , please follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to play again.
5. If the unit still does not work, install a brand new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department
at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by
going to our website vtechkids.com and filling out our Contact Us form
located under the Customer Support link. Creating and developing
VTech products is accompanied by a responsibility that we take
very seriously. We make every effort to ensure the accuracy of the
information, which forms the value of our products. However, errors
sometimes can occur. It is important for you to know that we stand
behind our products and encourage you to contact us with any
problems and/or suggestions you might have. A service representative
will be happy to help you.
Note
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by

8
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5422
Product Name: Marble Rush™ Launchpad Set™
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200,
Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.

Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty
TM & © 2021 VTech Holdings Limited.
All rights reserved.
Printed in China.
91-003989-000 US