V-tech Fix-It Buddies Toolbox Series Assembly Instructions

Parent’s Guide
Fix-It Buddies ToolboxTM
91-003459-009 US CAN

2
INTRODUCTION
Thank you for purchasing the Fix-It Buddies Toolbox
™
by VTech®.
This role-play toolbox features realistic tools: hammer, saw and
screwdriver. Your little one can tap the nail, saw back and forth on the
wood, and turn the screw with the screwdriver—all while learning about
colors, numbers and counting. Hear a variety of playful sounds and
melodies as the tools are used and replaced in the toolbox.
Hammer
Wood
Screw
Saw
Nail
Screwdriver
On/Off/Volume
Switch

3
INCLUDED IN THIS PACKAGE
• One Fix-It Buddies Toolbox
™
• One hammer
• One screwdriver
• One saw
• One parent’s guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties and packaging screws are not part of this
toy, and should be discarded for your child’s safety.
NOTE:
Please keep this parent’s guide as it contains important information.
ATTENTION :
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes et vis d’emballage. Ils ne font pas partie du jouet.
NOTE :
Il est conseillé de conserver ce guide des parents car il comporte des
informations importantes.
Unlock the packaging locks:
Rotate the packaging lock counterclockwise
90 degrees.
Pull out the packaging lock.

4
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of
the toolbox. Use a screwdriver to loosen
the screw.
3. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten
the screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.

5
PRODUCT FEATURES
1. On/Off/Volume Switch
To turn the unit On, slide the On/Off/
Volume Switch to the Low Volume
or High Volume position. You
will hear a song, phrase and fun sound.
To turn the unit Off, slide the On/Off/
Volume Switch to the Off position.
2. Automatic Shut Off
To preserve battery life, the Fix-It Buddies Toolbox
™
will
automatically power down after approximately 90 seconds without
input. The unit can be turned on again by pressing any button.
NOTE: If the unit powers down while playing, we suggest changing
the batteries.
ACTIVITIES
1. Hammer and Nail
Use the Hammer to tap the Nail and
learn about colors, numbers, counting
and hear a variety of playful sounds
and melodies.You will also hear playful
phrases inviting you to find other tools.
The light will flash with the sounds.

6
2. Saw and Wood
Use the Saw to saw the Wood and
learn about colors and opposites and
hear a variety of playful sounds and
melodies. You will also hear playful
phrases inviting you to find other tools.
The light will flash with the sounds.
3. Screwdriver and Screw
Use the Screwdriver to turn the Screw
and learn about colors and opposites
and hear a variety of playful sounds
and melodies.You will also hear playful
phrases inviting you to find other tools.
The light will flash with the sounds.
4. Tool Slots
Insert or remove the tools from the
Tool Slots to hear the tools identify
themselves and fun characteristics
about each tool. You will also hear
construction sounds, melodies, and the
tools singing songs about themselves.
The light will flash with the sounds.

7
SONG LIST
Song 1
Tap and count, 1-2-3.
Slide the saw back and forth.
Turn the screw round and round.
We’ll get the job done quickly.
Song 2
I’m a powerful hammer, I hammer in nails,
Bang, bang, bang, my work is done.
Song 3
I’m a hand saw, I have sharp teeth,
Slide me back and forth to cut the wood.
Song 4
I’m a screwdriver, I turn the screws,
Twist me, turn me, round and round.
MELODY LIST
1. Bingo
2. Alouette
3. Georgie Porgie
4. One, Two, Buckle My Shoe
5. I’ve Been Working on the Railroad
6. Mary Had a Little Lamb
7. One Man Went to Mow
8. She’ll Be Comin’ Round the Mountain
9. Skip to My Lou
10. Ta-ra-ra Boom-de-ay
11. Yankee Doodle
12. Chopsticks
13. The Bear Went Over the Mountain

8
14. Hickory, Dickory, Dock
15. Blow the Man Down
16. Boys and Girls Come Out to Play
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2.
Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries when the unit is not in use for an extended
period of time.
4. Do not drop the unit on a hard surface and do not expose the unit
to excess moisture.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow
these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit will now be ready to play again.
5. If the product still does not work, replace with an entire set of
new batteries.

9
If the problem persists, please call our Consumer Services Department
at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, or by
going to our website at vtechkids.com and filling out our Contact Us
form located under the Customer Support link. A service representative
will be happy to help you.
IMPORTANT NOTE:
Creating and developing VTech®products is accompanied by a
responsibility that we at VTech®take very seriously. We make
every effort to ensure the accuracy of the information, which forms
the value of our products. However, errors sometimes can occur.
It is important for you to know that we stand behind our products
and encourage you to call our Consumer Services Department at
1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, or by
going to our website at vtechkids.com and filling out our Contact Us
form located under the Customer Support link with any problems
and/or suggestions that you might have. A service representative
will be happy to help you.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:

10
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
CAN ICES-3 (B)/NMB-3(B)
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
Supplier’s Declaration of Conformity
Trade Name: VTech®
Model:
Product name:
Responsible Party: VTech Electronics North America, LLC
Address: 1156 W. Shure Drive, Suite 200,
Arlington Heights, IL 60004
Website: vtechkids.com
5225
Fix-It Buddies Toolbox
™

11

Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
TM & © 2019 VTech Holdings Limited.
All rights reserved.
Printed in China.
91-003459-009 US CAN