V-tech Storytime With Sunny User manual

Instruction Manual

2
INTRODUCTION
Thank you for purchasing the Storytime With SunnyTM toy!
Get ready to experience a new kind of companion who tells stories,
jokes and more.
INCLUDED IN THE PACKAGE
•Storytime With SunnyTM
• 4 Activity Disks
• Disk Rack
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not
part of this toy and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important
information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches, étiquettes et vis d’emballage. Ils ne font pas
partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’instructions car il
comporte des informations importantes.

3
Rotate the packaging locks 90 degrees
counterclockwise.
Pull out the packaging locks and discard.
Unlock the Packaging Locks
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit, use
a screwdriver to loosen the screws, and then open the battery
cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 6 new AA (AM-3/LR6) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries
or fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten
the screws to secure.
Remove Sunny’s protective cover by
pulling upwards.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

4
TO EXIT DEMO MODE
To exit Demo mode, insert a disk on the base and press the Power
Button. Storytime With SunnyTM will then be ready to play!
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
•Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
•Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
•Remove rechargeable batteries (if removable) from the toy
before charging.
•Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.

5
PRODUCT FEATURES
Hardware Input Responses
1. Power Button
Press the Power Button to wake up Sunny.
2. Save Battery Switch
Toggle the Save Battery Switch to play activities without
movements.
3. Light Button
Press 1 time to turn on the light on Sunny’s face.
Press 2 times to turn on the the light on Sunny’s face and the ring
around it.
Press 3 times to turn off the light.
4. Clock Button
Press the Clock Button to display the time if the time has
previously been set.
Setting the Time
1. Press and hold the Clock Button and Play Button together
until the time menu is activated, or about 5 seconds.
2. The hour section is active by default. The selection goes from
1 to 12. To select the hour, rotate the turning plate clockwise
or counterclockwise until the desired hour appears.
3. Press the Next Button to toggle between the hour section
and the minute section.
4. Minutes go from 00 to 59. To select the minutes, rotate the
turning plate until the desired number of minutes appears.
5. To confirm the time, press the Checkmark.
Speaker Exit button
Next button
Microphone
Checkmark
Play/Pause
Clock button
Light button
Turning plate
Disk recognition
Selection indicator
Vol +/-
Power
Save battery switch
Connector for
power adapter

6
Setting the Alarm Clock
1. Press the Clock Button and Checkmark together until the
alarm menu is activated, or about 5 seconds.
2. Use the steps for setting the hour and minutes as described in
the Setting the Time section above.
3. To confirm the alarm, press the Checkmark.
The alarm bell icon will be present when the Clock Button
is pressed to indicate an alarm is set.
How to Disable or Change the Alarm Clock
1. Press the Clock Button and Checkmark together until the alarm
menu is activated, or about 5 seconds.
2. The previously set alarm time will flash on Sunny’s face.
3. To disable the previously set alarm time, press the Clock Button.
4. To change the previously set alarm time, follow steps 2 to 5 of
the Setting the Time section above.
5. To keep the previously set alarm time, press the Exit Button.
Time to Wake Up
Before the alarm clock rings, Sunny’s light turns on to indicate
that it is almost time to wake up.
- 10 minutes before the alarm rings, her face lights up.
-5 minutes before the alarm rings, both her face and light ring
light up.
5. Play/Pause Button
Press the Play/Pause Button to start or pause the selected activity.
6. Next Button
Press the Next Button to skip an activity that is currently playing.
Continuously press the Next Button to cycle through the activities
of the selected category.
7. Checkmark
Press the Checkmark when prompted in an activity to answer
questions and interact with Sunny.
8. Exit Button
Press the Exit Button to stop and exit an activity.

7
9. Power Adapter
In addition to being battery powered, Storytime With SunnyTM can
be connected to a wall outlet via power adapter (not included).
The power adapter does not charge the toy. If there are no
batteries installed in the unit, it will only be playable when the
toy is plugged in.
10.Motion Sensors
Some activities use Motion Sensors to detect the
player’s movements. For optimal performance of
the Sensors, it is best to move away from direct light
(sunlight or indoor light).
11. Microphone
Some activities use the Microphone to detect sounds such as
clapping. For optimal performance of the Microphone, it is best
to be in close proximity to Sunny.
12. Automatic Shut-Off
To preserve battery life, Storytime With Sunny™ will automatically
shut off after approximately 5 minutes without input. The unit can
be turned on again by pressing the Play Button or Power Button.
NOTE
If the unit powers down or if the light fades out during play, please
install a new set of batteries.
Motion
sensors

8
Overview of the 4 Included Disks
Disk 1 - My Great Day
- Daily routines, manners and mindfulness.
Disk 2 - You and I
- Friendship, laughter and imaginative play.
Disk 3 - Stories and Songs
- Listen, laugh, get up and groove.
Disk 4 - Silly Games
- Fun problem-solving and creative games.
Attaching the Disk Rack
To attach the disk storage to the base, insert the round part of the
rack into the hole located under the base of Storytime With SunnyTM.
Then store the four disks.

9
Connecting the Adapter (Not Included)
• Make sure the unit is turned Off.
• Connect the adapter to the Power Adapter Port of the unit.
• Plug the adapter into a power socket.
Note: The use of an adapter will override the batteries.
Safety Information When Using Power Supply for Toys
•VTech recommends a power supply (AC/DC adapter) of the
below specification:
•This toy shall only be used with a power supply for toys with
output DC 5V.
• The power supply is not a toy.
• The toy is not intended for children under 3 years old.
•Do not connect the toy to more than the recommended number
of power supplies.
• Never clean a plugged-in toy with liquid.
•As with all electrical products, precautions should be used and
observed during handling and use to prevent electric shock.
• Do not leave the toy plugged in for extended periods of time.
• Please examine the power supply periodically for conditions
that may result in the risk of fire, electric shock, or injury to
persons (such as damage to the supply cord, output cord, plug,
blades, housing, or other parts) and that, in the event of such
conditions, the power supply should be discarded.
•Power supplies for toys are not intended to be used as toys,
and the use of these products by children shall be under the full
supervision of parents.
AC Adapter Electrical Ratings:
Input: ~ 120VAC, 60Hz (for US); ~ 230VAC, 50Hz (for UK or EU);
~ 240VAC, 50Hz (for AS/NZL)
Output: DC 5V, 1.5A, 7.5VA

10
CARE & MAINTENANCE
1 . Keep the unit clean by wiping it with a slightly damp cloth.
2.
Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4.
Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
5. Yanking or pulling on the mechanical arm may cause damage to
the product.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and filling
out our Contact Us form located under the Customer Support
link. Creating and developing VTech products is accompanied
by a responsibility that we take very seriously. We make every
effort to ensure the accuracy of the information, which forms the
value of our products. However, errors sometimes can occur. It
is important for you to know that we stand behind our products
and encourage you to contact us with any problems and/or
suggestions you might have. A service representative will be
happy to help you.