V-tech Go! Go! Cory Carson RC Cory Carson 5459 Assembly Instructions

RC Cory Carson™
Parents’ Guide
91-003997-001 US

2
INTRODUCTION
Thank you for purchasing the Go! Go! Cory Carson®
RC Cory Carson™!
Let’s have fun with Cory! Use the two button remote control to move
Cory forward, turn and do tricks. Press the light-up button to hear fun
phrases, sounds and music from the show.
Come on, let’s go!
Forward Button
Spin Button
On/Off Switch
Light-Up
Windshield Button

3
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please keep this parents’ guide as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de conserver ce guide des parents car il comporte des
informations importantes.
Removing the Packaging Locks
Turn the packaging locks counterclockwise
several times.
Pull out the packaging locks and discard.
Rotate the packaging locks 90 degrees
counterclockwise.
Pull out the packaging locks and discard.
INCLUDED IN THIS PACKAGE
Go! Go! Cory Carson®RC Cory Carson™
• 1 RC Cory Carson™
• 1 remote control
• 1 Parents’ guide

4
INSTRUCTIONS
Battery Removal and Installation
Car
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver
to loosen the screw and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries
following the diagram inside the battery
box. (For best performance, alkaline batteries or fully charged
Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
Remote Control
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of the unit, use a screwdriver to
loosen the screw and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR3) batteries following the diagram inside
the battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

6
PRODUCT FEATURES
1. On/Off Switch
To turn the unit On, slide the On/Off
Switch to the On position.To turn
the unit Off, slide the On/Off Switch
to the Off position.
2. Automatic Shut-Off
To preserve battery life, RC Cory
Carson™ will automatically power
down after approximately 100
seconds without input. The unit
can be turned on again by pressing
Cory’s Light-Up Button.
3. Remote Control
Use the Forward Button to move
Cory forward and the Star Button
to back up, turn and do tricks. Cory
will play fun sounds while driving.
The Remote Control will not work if
the vehicle is in Sleep mode.
Note
If the unit repeatedly powers down while playing or the light fades
out, we suggest changing the batteries.
Note
This product is in Try-Me mode in the packaging. After opening the
package, turn the unit off and on again to proceed with normal play. If
the unit powers down while playing, please install a new set of batteries.

7
ACTIVITIES
1. Light-Up Button
Press the Light-Up Button to hear
fun songs, exciting phrases, sounds
and music. The light will flash with
the sounds.
2. Forward Button
Press the Forward Button to move
Cory forward with fun sounds and
phrases. The light will flash with the
sounds.
3. Star Button
Press the Star Button to back up,
turn and do tricks while playing
fun sounds and phrases. The light
will flash with the sounds.

8
MELODY LIST
1. Sidewalks of New York
2. Row, Row, Row Your Boat
3. Oh Dear What Can the Matter Be
4. Chicago (That Toddling Town)
5. Skip to My Lou
6. One Man Went to Mow a Meadow
SONG LYRICS
Song 1
Are you ready to have fun?
Ready or not, here I come!
Song 2
Hurry up! Hurry up! This way!
Yeah! Yeah! Let’s go!

9
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to play again.
5. If the unit still does not work, replace with a new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and filling out our
Contact Us form located under the Customer Support link. Creating
and developing VTech products is accompanied by a responsibility that
we take very seriously. We make every effort to ensure the accuracy
of the information, which forms the value of our products. However,
errors sometimes can occur. It is important for you to know that we
stand behind our products and encourage you to contact us with any
problems and/or suggestions you might have. A service representative
will be happy to help you.

10
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
RF warning statement:
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.

11
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
CAN ICES-003(B)/NMB-003(B)
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5459
Product Name: Go! Go! Cory Carson®
RC Cory Carson™
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200
Arlington Heights, IL 60004
Website: vtechkids.com

91-003997-001 US
Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
vtechkids.ca
TM & © 2021 VTech Holdings Limited.
All rights reserved.
Printed in China.
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty